machine safety
OSHA
Wood types
Finish work
general construction
200
This tool is used for a table saw to keep hands away from the blade
push stick
200
This federal agency is responsible for creating and enforcing workplace safety regulations in the USA
OSHA
200
Pine is classified as what type of wood?
soft wood
200
What stationary tool is used to drill clean, precise holes straight up and down?
drill press
200
What is the minmum height at which fall protection is required on a construction site?
6 feet
400
this system removes fine wood from the air to prevent fire and breathing risk
dust colector
400
Who should Workers report unsafe conditions on the jobsite to
Supervisor or Mr Inman, I guess
400
Name the types of grain on this wood
end grain face grain edge grain
400
What is the smallest unit of measurement that a sander moves up and down in?
0.01"
400
When cutting plywood along the grain, what's it called?
ripping plywood
600
Before sanding lumber through a sander or planer, you must check for what
nails, metal, or sharp objects
600
What does OSHA stand for
Occupational Safety and Health Administration
600
What is plywood made from?
Thin layers of wood glued together
600
What tool is commonly used to drive finish nails without leaving large marks on trim or molding?
nail set
600
What does HVAC stand for
Heating, Ventilation, Air Conditioning
800
What mighty device, powered by motor’s force or engine’s roar, doth draw in the very breath of the open air, and press it tight within an iron vessel, only to release it again in fierce and mighty gusts, that it may drive nail-guns, wrenches of impact, and sprays of paint with thunderous obedience to man’s command?
air compreser
800
OSHA requires workers to keep floors clean of sawdust and oil spills to prevent slips and injuries
What is hazards and clutters
800
What does OSB stand for
Oriented Strand Board
800
A worker uses a handheld or tabletop power tool with a fast-spinning bit to cut shapes, hollow out wood, and create clean edges or joints in finish carpentry, such as cabinets and trim work. What tool is it
router
800
what are these tools used for 
to measure elevation
1000
This device sits behind the blade of a table saw and prevents wood from punching the blade, causing kickbacks
rivingt knife
1000
when was osha made
December 29, 1970
1000
This grain pattern exposes the ends of wood fibers, causing it to absorb stain much faster and darker than other surfaces, often leading to uneven finishing unless properly sealed or conditioned.
end grain
1000
This is the term for a wood’s tendency to shrink, swell, or twist as moisture content changes.
What is wood movement or dimensional stability?
1000
A wall section is being framed for a 8-foot-tall structure, but the finished floor and drywall thickness must be accounted for. What would the approximate cut length be for a standard wall stud in this assembly?
92 5/8