State laws and rules
HOW OLD MUST AN APPLICANT BE TO BE ELIGIBLE FOR THE STATE BOARD EXAM
16 YEARS OLD
space between two lines or surfaces that intersect at a given point
angle
points on the head that signal a change in the shape of the head, from flat to round or vice versa.
four corners
to divide the hair by parting into uniform working areas for control.
sections
Pin curls are made up of three principle parts. What are they?
base, stem and circle
TEMPORARY LICENCES ARE GOOD FOR?
9 MONTHS
highest point on the top of the head.
apex
direction in which the hair grows from the scalp; also referred to as natural fall or natural falling position
growth pattern
haircutting technique in which the hair is held in place with the comb while the tips of the scissors are used to remove the lengths.
scissor over comb
With a pin curl, what determines the width of the wave and its strength
the size of the circle
WHEN IS A SCHOOL OR SHOP SUBJECT TO INSPECTION
ANYTIME
parting the haircut in the opposite way from which you cut it, to check for precision of line and shape.
cross checking
create movement and volume in the hair by releasing weight.
layers
guideline that does not move.
stationary guideline
This type of pin curl base is usually recommended at the side front hairline for a smooth upswept effect.
rectangular base
MEASUREMENTS FOR A ONE OPERATOR SALON
180 SQ FT
angle at which the figners are held when cutiint, and ultimately the line that is cut; aslo known as finger angle, finger positon,cutting angle.
cutting line
version of point cutting in which the tips of the scizzors are moved toward the hair ends rather than into them created a chunkier effect
notching
amount of pressure applied when combining and holding a section, created by stretching or pulling the section.
tension
These are pin curls placed immediately behind or below a ridge to form a wave.
ridge curls
HOW MANY CONSECUTIVE TERMS CAN A BOARD MEMBER SERVE
2 TERMS
where and how hair is moved over the head.
distribution
widest area of the head, usually starting at the temples and ending at the bottom of the crown.
parietal ridge
hair is elevated to 90 degrees from the scalp and cut at the same length.
uniform layers
This brush is used to speed up the blowdrying process and are ideal for blowdrying fine hair and adding lift at the scalp.
vent brushes