Who's Responsible
This party may make a decision to confirm, vary, or cancel a Board decision.
What is a Review Officer
As shown in Figure 13-1 a ladder must be positioned against a vertical plan at this angle, when measured against the horizontal plane.
What is 75 degrees
Purchasing and inventory, hazard identification, inspections, and worker education and training are all a part of this.
What is a WHMIS Program
Must be kept back a minimum of 2 feet from a trench excavation and 4 feet from any other excavation.
What is excavated material
Hazards for each work area, systems to be used, procedures to assemble, maintain, and inspect the systems are all elements of this.
What is a fall protection plan
This party is responsible to ensure that personal protective equipment is not worn outside of the work area where it is required to do so if it would constitute a hazard.
Who is the worker
This is the load rating for a CSA 1A or ANSI 1A ladder.
What is 300 lbs
This requires a product name, safe handling precautions, and reference to the SDS.
What is a workplace label
Flyforms, ganged forms and suspended forms are types of forms that require these.
What are worksite-specific plans
This is the height at which chin straps must be worn.
What is 10 feet
This party must consult with workers and the employer on issues related to health and safety and occupational environment.
Who is the Joint Committee
The standard that job built ladders must be built too.
What is the WCB Standard LDR 1, Job Built Ladders, 2004
Categories of this include reproductive toxins, sensitizers, L endnotes and A1.
What is a designated substance
This is the time length that employers must ensure washroom cleaning records are kept for.
What is 30 days
This must have an ultimate load capacity of 800 lbs or four times the weight of the worker.
Fall restraint system anchor
This party must provide the name of the person designated to be responsible for workers at a workplace to the party coordinating health and safety.
Who is the employer
This type of work does not require fall protection when done from a ladder.
Light duty, short duration work
Portable self-contained wash units at transient worksites with products that have a high or moderate risk of injury to eyes or skin, must be capable of delivering a minimum flush duration of this.
What is 15 minutes
This organization's practice guideline describes the standards of practice that should be followed when carrying out equipment inspections including concrete pump trucks.
What is the Engineers and Geoscientists of BC (EGBC)
As per guideline, guardrail systems can be used on roofs with slopes less than this slope.
What is 8:12
This party must provide direction respecting the safe use of any tool, equipment, machine or device that is to be used at a workplace by workers.
Who is the supplier
Ladder jack systems require these minimum standards of ladders to be aligned with ANSI 14.2.
What is I, IA, and IAA.
The information included in section 7 of an SDS sheet.
This is the height chutes must be provided if there is free fall of materials or debris from an upper area.
What is 20 feet
This is the Canadian standards association's standard for various types of fall protection equipment.
What is Z259