Drawing Types
Inventor
Statistics
Measurement
Misc.
100
This drawing type is set at a 60 degree angle
What is Isometric?
100
This type of drawing shows all the parts put together.
What is an assembly drawing?
100
This is the number that occurs most often in a data set
What is the mode?
100
This is a tool used to measure precisely down to the thousandth's of an inch
What is a dial caliper?
100
This is a full-scale physical model an engineer would use to demonstrate how a design functions under actual working conditions.
What is a prototype?
200
This drawing type goes back towards two vanishing points
What is a 2 point perspective drawing?
200
This is the type of file you start with in Inventor
What is an .IPT or a part file?
200
Engineers specify this to indicate the amount of dimensional variation that may occur without adversely affecting an objects function
What are tolerances?
200
In a 1/4-20 UNC x 2 in bolt the 1/4 stands for this.
What is the number of threads per inch?
200
Engineers create these of their designs out of temporary and inexpensive materials, and use them for instructional or experimental purposes.
What is a mock- up?
300
This type of drawing is done freehand and without the use of drawing tools
What is sketching?
300
A cutting plane line is used in this type of drawing.
What is a section view?
300
This is a number that represents the average amount of variation that the values in a data set exhibit from their mean value.
What is the standard deviation?
300
5/16th of an inch is equal to this many millimeters
What is 7.94 inches?
300
Arcs and circles that share the same center point are said to be this
What is concentric?
400
This drawing type is set a 45 degrees and shows half the depth of the object.
What is a cabinet oblique?
400
This drawing tool is used make a silhouette of an object into a round shape.
What is the revolve tool?
400
The Y-axis on a histogram shows this of occurrences for each of the data elements given on the x-axis.
What is frequency?
400
Sometimes its necessary to do this to a large or small technical drawing so that fits on the drawing sheet.
What is to scale?
400
A table of information located in the bottom right-hand corner of an engineering drawing is called this
What is a title block?
500
The "box method" is used to maintain these of the actual object.
What is proportions?
500
This type of drawing shows how parts fit together and contains a parts list.
What is an exploded assembly?
500
This is the range of this data set 59, 72, 96, 85, 87, 92, 65
What is 37?
500
These are the different methods used to measure with a dial caliper.
What are outside diameter, inside diameter, step distance, and hole depth
500
This is a record keeping document that is used by designers to record daily project work and legally prove the origin of an idea.
What is an engineer's notebook?
M
e
n
u