Novar
What are two names for Novar?
What is Novar and ESS32
What Session type do you connect to in Opus Architect?
What is Station Connection.
What is the Username and Password to Access a Danfoss 880 store?
What is Supervisor and #5and10#.
What are 2 other names for CPC?
What does the designation LTA stand for?
Where do you search for Comm Loss in Novar?
What is in (8) Mod. Config.
What color does Purple represent in Opus (Architect/Magnum)?
What is a Force
What Auth Code and Account # in Danfoss AKA65 do you need to Rescan Channels?
What is Auth Code - 2002, Account # - 25.
How do you log into a store in CPC?
What is Right click on the store and select 'Connect'.
What does the designation A04b* MD MEAT stand for.
What is Rack A>Case 04>Bravo>and it's a controlling circuit.
A Tech calls you and asks that you Force a Phase Loss. Show me the Wiki Article that walks you through the steps to do this process.
In Opus where do you go to find your Inputs for SucP.?
How do you perform a rescan in Danfoss StoreView?
What is Configuration>Select Rack> network node> Node overview> Press for Complete Rescan.
How often should you run CPC's Get US Database?
What is Daily.
What is the acceptable range for a rack's DisP?
What is 100-325psig.
Where do you force the SucP in Novar?
What is Enter the Rack, (8) Mod Config, RIM, Tab to Analog Inputs.
Can you show me how to Force a Phase Loss for HVAC in Opus?
What is refer to this Wiki article:
https://teams.wal-mart.com/sites/BCKnowledgebase/Pages/OPUS%20-%20How%20to%20Force%20a%20Phase%20Loss%20for%20HVAC.aspx
And Demonstrate
Where do you find Refrigeration in AKA65?
What is You don't, all refrigeration is in StoreView.
How do you force a defrost in CPC?
What type of receiver sensor will output a binary value (open/closed | active/inactive)?
What is a Float Switch.
How do you find the SucP SP in Novar?
What is the 4 1's
Can you show me the Link to find out how to change a Breaker Type from 3 to 4 Wire in Opus?
When do agents perform point changes in StoreView?
What is Never, you must submit a DAE!
How do you check for Comm Loss in CPC? (Show me the steps)
What is:
>Log into your store
>Right click on desired controller
>Select Device Setup
>Network/Board Setup
If a case is in fault in Novar ESS32 what will it show you?
What is -39.5.