Drill Bits
What is the most common type of drill bit used.
Twist Bit
What is the most common type of drill seen/used today?
Cordless Drill
What is a smaller hole drill into the board prior to a screw being inserted?
Pilot Hole
What must be done to the stock prior to drilling.
Clamped
What powers a cordless drill?
Battery
What is the drill bit most used by electricians to drill holes quickly through studs.
Auger Bit
What is the stationary tool that does the same job as the cordless drill?
Drill Press
What is a hole that goes all the way through a board?
Through Hole
What is the only tool that you can start the tool in contact with the wood?
Cordless/corded drill
What holds the bit in the drill/drill press?
Chuck
What is the bit which also has the nickname "paddle bit".
Spade Bit
What is the tool that many homeowners keep in a kitchen drawer?
Cordless Screwdriver
What is a conical or funnel shaped hole cut into the top of a board to allow the head of a screw to sit flush with the top of the board?
Countersink
What must you always wear when using a drill?
Safety Glasses
What disengages the motor from the chuck.
Clutch
What is the tool used mostly by plumbers?
Hole Saw
What is the tool that makes driving screws and lag bolts easier?
Impact Driver
What is a hole that is drilled into a board but does not go all the way through?
Non-through Hole
What you must pull back/tie up before using the drill press.
Hair
What is used to set the depth on the drill press?
Depth Adjustment Lock
What is the bit that drills a flat bottomed hole?
Forstner Bit
What is the tool used to drill in concrete/masonry that has a hammering action?
Hammer Drill
What is a hole which has a flat bottom that allows a screw or bolt to sit below the surface of the wood?
Counterbore
Which side should your material being hanging off of the drill press table.
Left
What is the part of the drill press which determines how far done the chuck can move?
Throat