A
Most common problem with CV joints.
What is torn or split boots?
The driveshaft is connected to this.
What is the rear drive train?
This is caused when oil gets on a clutch disc.
What is slippage?
Name the 3 clutch release methods.
What is cable, mechanical, and hydraulic?
This is another name for release bearing.
What is throw out bearing?
The primary function of a transmission.
What is gear reduction?
A torque converter is actually just a _____.
What is a fluid coupler?
When checking the fluid in a manual transmission/transaxle, what indicates the correct amount?
The fluid reaches the bottom of the fill hole.
When the clutch pedal is pressed down, the clutch is _____.
What is disengaged?
The function of clutch torsion springs.
What is What is reduce the shock during engagement?
A high-pitched squeal or grinding noise when the clutch plate is first pressed is most likely _____.
What is a bad release bearing?
The small clearance required between meshing gears for lubrication and heat expansion is called _____.
What is backlash?
What supports the slip yoke of a one-piece driveshaft assembly?
What is the tailshaft housing and bushing?
This allows a U-joint to flex.
What is the needle bearings and bearing cups?
A ring & pinion set, with 41 and 15 teeth respectively, has a gear ratio of 3.11:1, 2.6:1, or 2.73:1?
What is 2.73:1?
Movement between yokes indicate a worn ____.
What is U-joint?
When the output shaft of a transmission turns faster than the input shaft, it is said to be in _____.
What is overdrive?
An internal clutch master cylinder leak will cause this condition.
What is clutch self-engagement?
Installing a clutch disc requires this tool.
What is an alignment tool?
Also called straight-cut, these gears are the ones in which only one tooth is in ideal contact with another tooth at anytime.
What is spur?
This axle type has the bearings pressed onto the axle shafts.
What is retainer plate type?
This is the first step to take when removing a driveshaft for U-joint replacement.
What is mark the shaft for reassembly?
If a transmission rear extension housing oil seal is leaking, the repair technician can do this in addition to replacing the seal.
What is check the shaft bushing or bearing for wear?
Low fluid in the clutch system can cause what condition?
What is loss of clutch disengagement?
This will be the result if a vehicle has zero clutch pedal Free Play.
What is the release bearing will turn all of the time?