1
2
3
4
5
100
Ohms law is expressed this way.
What is E= I x R
100
If you measure current flow at each leg and total this, what kind of circuit is this.
What is parallel?
100
In a parallel circuit all resistors are the same, 100 ohms and there are three of them. What do you do to get resistance total.
What is divide 100 by 3?
100
What type of circuit is amperage the same throughout the circuit.
What is series circuit?
100
In a series circuit measuring amperage at different places your readings should be
What is the same?
200
Three bulbs wired in series with total resistance of 12, what is the resistance of each bulb.
What is 4 ohms?
200
You have 12 volts and 3 amps. What is the wattage.
What is 36 watts?
200
If you have infinite resistance the circuit is what.
What is open?
200
If you have a circuit that all available amperage flow through it, how much resistance is there.
What is 0?
200
Voltage used pushing current through a load in a circuit is called________.
What is Voltage drop?
300
Corrosion will contribute to a higher than normal what.
What is voltage drop?
300
Corrosion in a circuit will cause this.
What is higher resistance?
300
This copper insulated product should cause very low resistance in a circuit.
What is wiring?
300

A reading of 0.286 would be displayed how on a DVOM.

What is 286 MV?

300
A test light and ohmeter can be used to test this 2 prong circuit protection device.
What is fuse?
400
You must remove the component from the circuit to measure this.
What is ohms or resistance?
400
When connecting your meter in series to a circuit you are testing for this.
What is amperage?
400
By checking voltage drop in a circuit you can find unwanted _______.
What is resistance?
400
Testing a blown fuse with your ohmeter the read should be _______
What is infinite or OL?
400
In this circuit total resistance is always less than any of its legs.
What is parallel?
500
You have 12.6 volts available for a 1 bulb circuit and you have a voltage drop of 12.6. What is wrong.
What is nothing, circuit normal?
500
A dimly lit bulb with source voltage of 12.6 volts has 6.6 voltage drop. What could cause this.
What is high resistance?
500
Where is most of the resistance found in a good operating circuit.
What is the load?
500
To check voltage drop in a circuit you must convert your DVOM this way.
What is in parallel?
500
If checking resistance your meter reads 0, this indicates what.
What is there is no resistance?
M
e
n
u