I Need My Space
A drip loop must have a minimum vertical clearance of ____ feet.
10 feet
The general lighting load multiplier for restaurants is __ Volt-amperes/square foot.
2
How many number 12 conductors can fit in a 4x1.5 inch square box.
10
RTU stands for what?
Roof Top Unit
EMT must be securely fastened within __ feet of a box.
3
The working space in front of electric equipment/panels must be the greater of the width of the equipment or ___ inches.
30 inches
Small appliance circuit load is calculated at ____ volt-amperes for each 2 wire branch circuit.
1500
Each yoke on a device is counted as ___ conductors.
2
When several runs of wire are pulled to feed the same service it is called _____ runs.
parallel
FMC must be fastened in place at intervals of ___ feet or less.
4.5
The minimum workspace depth (space in front of the panel) for equipment operating at 150 volts, nominal (or less) to ground, is ___ feet.
3 feet
If there are 4 or more fixed appliances then you can apply a demand factor of ___ percent of each nameplate rating.
75
A number 8 wire is __ cubic inches.
3.00
When you make one bend to move a 90(a 90 bent on a piece of pipe) up or down, it is called a ____ 90.
kick
Unbroken lengths of EMT, i.e., without coupling, can be fastened within ___ feet of the box when structure will not allow the usual distance.
5
The minimum workspace height for electrical equipment is ___ feet.
6.5 feet
One of the methods to calculate the receptacle load of banks and office buildings is to multiply the square feet by ___ (volt-ampere/square foot)
1
How many THHN number 12 wires can fit into 1 inch EMT?
26
the copper wire tied to the steel in the slab is called a ____ ground.
Ufer
MC will be strapped in intervals of no more than __ feet.
6
The minimum cover requirement for pvc running under a parking lot is ___ inches.
24 inches
What is the demand factor for 8 dryers.
60 percent
How many 250 kcmil THHW wires can fit into 4 inch rigid pvc?
9
The short name of a strap to hold pipe without making box offsets.
mini
Surface metal raceways and associated fittings shall be supported in accordance with _________.
manufacturer's installation instructions