Safety
Is the most common article of PPE
Safety Glasses
This tool can be set to newton meter and foot pounds
Torque Wrench
The bottom right corner of a schematic is known as a ____ ______
Title Block
This toothed wheel is used to mesh with a chain
sprocket
This parallel cut gear is known as a
spur gear
Is a standardized document for chemical manufacturers detailing a substances hazards.
SDS or safety data sheet
This chemical comes in different weights and is meant to lubricate gears
OIL
All Schematics are drawn in a ________ state
De-energized
This type of link is used when there is an uneven amount of chain
Offset link
This gear is known for high speed, quite operation
helical gear
When climbing ladders you must maintain ________ contact
3 points
This threaded metal nozzle on machinery that serves as a one-way valve to inject lubricant
Grease Zerk
This detailed technical Drawing, with precise measurements is known as a
Blueprint.
This tool is used to hold chain together for connecting
Master link pliers, quick link chain tool.
If the drive gear has 200 teeth and the driven gear has 100 teeth the ratio is
1:2 ratio
Flame resistant (FR) clothing is rated by its ARC rating. Measured in _______________
CAL Calories per square inch
This type of maintenance involves replacing parts before the failure is expected
Preventative.
In IEC schematics, a Q depicts this component
Breaker
chain drives greater than ____ are vertical and should be at ____ chain sag
60, 2%
A combination square is used to detect _____ ______ misalignment.
Vertical Angular
______ _________ straps are a requirement on harnesses.
Suspension Trauma
What is the goal of a preventative maintenance program
Eliminating failures, eliminating excessive down time. Eliminating potential machine damage.
A dot shown at a line intersection is known as a ______
Connection
This technical term for chain stretch, which is considered a failure is known as
chain elongation
This type of gear change the direction of motion by 90 degrees
Bevel gear