Enterprise Tool & Die
This area is where sheet metal and drum fluids are kept.
What is the coil room?
1.5x diameter of screw
What must be present to protect pinch points on conveyors?
What is guarding?
This is where all our first aid equipment is kept.
What is the old phone booth by the band saw?
This is the document that gets filled out while a die is in the build stage.
What are the assembly guidelines?
This is the process of putting a process together and submitting cost and timing.
What is estimating/quoting?
All tools will be warranted for craftsmanship until this amount of strokes are complete. (within 5,000)
50,000 strokes
This needs to be filled out if someone gets injured on the jobsite.
What is an accident report?
This should be done if someone cuts their hand badly.
What is cover it with something clean and apply pressure or use a tourniquet?
This is the document that gets filled out while a die is in the tryout stage.
What are the tryout guidelines?
Who is Michael, Kevin, and Josh?
This is the percentage of material thickness that our trimming/piercing steels are designed to.
What is 10%
This is needed when lifting a load over 5 ft off the ground.
What is a hard hat?
This is the process of cutting off all power to a machine that is not safe to use.
What is Lock-Out Tag-Out?
This is the document that gets filled out when something doesn't work out or doesn't go as planned.
What is in NCMR?
This is the person that you go to when Michael and Myself are tied up in meetings.
Who is Rob Powers?
This must be present in posts and cavities when applicable in adequate non-working areas.
What are vent holes?
This is the max opening distance for the work rest on a bench grinder.
What is 1/8"?
These are located on the front and back of the presses that are able to go into continuous mode.
What are light curtains?
This is the person that you text/call when you are unable to make it into work.
Who is your direct supervisor?
This is the industry that we do 60% of our business in.
What is automotive?
Carrier flanges should be formed over lower post having this geometry.
What is square lower form, no radius on inside of part
This is the max opening distance for a tongue guard on a bench grinder.
This is the distance that you should carry a load on the forks of a hilo while moving.
This must be done before a part is given to quality to complete a layout.
What is hand checking a part?