If, after installing a fitting for the purpose of recovering the appliance's refrigerant, you find that the system pressure is 0 psig
Refrigerant recovery is not required
What is an approved "drop in " refrigerant for R-22 ?
None ! There is no such thing as a direct drop-in replacement !!!!
Soap bubble testing is used when?
What is pinpointing refrigerant leaks
Pressure 595 PSIG
Temperature 45 degrees F
What is R-744 ( CO2 )
What is the maximum leak rate for comfort cooling ?
10% of the charge per year.
Pressure 9.7 PSIG
Temperature 20 degrees F
What is R-1234ze
Refrigerant recovery and/or recycling equipment manufactured after _______________ must be certified and labeled by an EPA-approved testing organization to meet EPA standards.
November 15, 1993
Applying heat, with a heat gun, to the compressor
Can help vaporize any trapped liquid refrigerant during recovery
On refrigeration units that use a belt driven compressor the (blank) is most likely to leak if the unit is not used for several months
What is the rotating shaft seal
Pressure 78.7 PSIG
Temperature 75 degrees F
What is R-134A
System-dependent or passive recovery equipment use for an appliance containing HCFCs or HFCs is limited to a maximum charge of ?
15 Pounds
What happens to a refrigerant that is heated above the saturation temperature?
It remains in the vapor state
Pressure 197 PSIG
Temperature 100 degrees F
R-717 ( Ammonia )
Systems charged with R-410A should be leak checked with?
What is pressurized nitrogen and a trace of R-410A Refrigerant
When a system is in a deep vacuum we should never energize the _________ .
Compressor
With a non-operating system compressor, recovery equipment must be capable of recovering
80 percent of the refrigerant or achieving 4 inches of vacuum
When using a recovery unit on a system containing 100 lbs. of R-410A it must be evacuated to ______ inches...
0 inches of Mercury
Pressure 26.9 PSIG
Temperature 65 Degrees F
R-600 ( Isobutane )