Definitions
Duty to have Fall Protection
Fall Protection Systems
Protection from Falling Objects
Fall Protection Plans
100
A gap or void 2" inches or more in its least dimension in a floor, roof, or other walking/working surface
Hole
100
Fall protection must be provided to construction workers who are working on surfaces or walking/working levels with unprotected sides and edges which are ______ above a lower level.
6-feet
100
A personal fall arrest system (PFAS) consists of ...
An anchorage, lanyard/connectors, and a full body harness
100
When an employee is exposed to falling object hazards, the employer shall provide and the employee shall wear a .........
Hard hat
100
Who is the person responsible for preparing and developing a fall protection plan when the use of conventional fall protection is not feasible...
Qualified Person
200
A roof having a slope greater than 4 in 12 (vertical to horizontal)
Steep roof
200
For workers on scaffolds, fall protection must be provided if they are working ________ above a lower level.
10-feet
200
Systems employers can provide to protect workers from falls....
Guardrails, PFAS (personal fall arrest systems), safety nets
200
Name one of the two methods of preventing falling objects to a lower level
Toe-boards and screens
200
Name the person who is responsible for implementing the fall protection plan at the job site?
Competent Person
300
Barrier erected to prevent employees from falling to lower levels
Guardrails
300
When climbing an extension ladder to access higher working levels, the ladder must extend ______ above the surface they are climbing onto.
3-feet
300
At what height are the Top-rail and Mid-rail required to be placed when used as guardrail system?
Top-rail = 42" inches +/- 3" inches
Mid-rail = 21" inches +/-3" inches
300
During overhand bricklaying work no materials or equipment except masonry and mortar will be stored within _______ feet of the working edge
4-feet
300
Employers must provide employees with fall protection equipment and complete employee ______________ when they can be exposed to fall hazards.
Training
400
A barrier (rope, wire, or chain) with supporting stanchions, erected on a flat or low-sloped roof to alert workers they are approaching an unprotected edge, and designates an area where work can be done without other fall protection.
Warning Line System
400
What activities may occur on low-slope roofs that permits the use of a safety monitor only?
Employees engaged in roofing activities only.
400
What is the minimum breaking strength of the board webbing or border rope on a safety net system?
5,000 pounds
400
During the performance of roofing work, no materials and equipment shall be stored within _______ feet of the of the roof edge unless guardrails are installed at the edge.
6-feet
400
Which employees may be permitted to work in a Controlled Access Zone (CAZ)?
Designated employees
500
A gap or void 30" inches or more high and 18" inches or more wide, in a wall or partition, through which employees can fall to a lower level
Opening
500
When excavations 6-feet or more in depth cannot be readily seen because of plant growth or other visual barriers, what must the employer provide to employees.
Fall protection
500
Hole covers shall be capable of supporting without failure at least _______ the weight of employees, equipment, and materials that may be imposed on the cover at any one time
Twice
500
Name two of the three components used for falling object and fall protection in this configuration.
Safety nets, screens, canopy
500
Name one of the two systems that uses stanchions and requires flagging every 6-feet.
Controlled Access Zone Control Lines
Warning Line System