3515
When testing transmit and receive with a 3515N the RF cable should be attached to the radio/amplifiers antenna port and the ____ port on the 3515N for a direct connect test.
T/R PORT
true or false :The RT-2062 is a two-channel software-defined radio system that hosts several operational waveforms and provides secure Internet Protocol based voice and data communications
true
The PRC in AN/PRC-117G stands for:
PORTABLE RADIO COMMUNICATION
The three main troubleshooting methods are:
Front to back, back to front, halfway
How many Watts of power can the 3515N test with no attenuator?
20 WATTS
A basic communication system is comprised of what 6 things
Microphone, Transmitter, RF transmission lines, Antenna, Receiver, Speaker
TRUE OR FALSE : The AN/VRC-104 and AN/MRC-148 both contain the same RT.
TRUE
This type of publication gives detailed technical data and instruction on the operation, repair, and troubleshooting of equipment.
TECHNICAL MANUAL
true or false: On a 3515N the duplex test allows you to test receive only.
FALSE
Which of these radio systems contain a Built-in Test (BIT) capability? and what button lets you access this function
RT-2060,RT-1949,RT-1916,RT-2062, 7 (OPT) BUTTON
WHAT IS The RF-5833 PA
POWER AMPLIFIER
WHAT IS THE TEST CALLED WHEN A RADIO POWERS ON
POST( POWER ON SELF TEST)
What is the ANT Connector on the 3515N used to test?
over the air test - can test failures without direct connection
Why should the radio be zeroized before troubleshooting?
To ensure that no prior programming or encryption is loaded in the radio.
The major difference between a VRC-114(v)1 and a VRC-114(v)2 is:
AN/VRC(v)2 utilizes two RT-1949’s and two RF-7800s
WHAT TEST ON THE MULTIMETER IS USED TO TEST RF CABLES
CONTINUITY TEST
What is the purpose of the Audio In connector on the 3515?
Receive external modulation input
The two types of BIT fault reporting on Harris radios are ______ BIT faults and ____________ BIT Faults.
Run-time, operator initiated
The RF-382 Antenna Coupler is connected to the RF-5833 with an RF Cable and a _________.
Coupler Control Cable
WHAT FORM IS USED WHEN YOU HAVE TO SEND A BROKEN COMPONENT TO A HIGHER LEVEL OF MAINTENANCE ?
NAVMAC 1018