Differentials/Ball Joints
Variety
Technical
Troubleshooting
Such
100
How is bearing preload adjusted in a differential?
Adding or removing shims
100
A growling noise is heard from the front of a vehicle when increasing speed and turning left. What could cause this?
Bad right wheel bearing
100
What is true about directional tread tires that is not true about the others?
They can only be mounted in one direction and side
100
Which of the following is a non-adjustable alignment angle that should be checked after setting the front toe.
1) Camber, 2) Caster, 3) Rear Toe, 4) TOOT
TOOT
100
Camp Verde High School Colors
White, Blue with Red Hilights
200
Use what tool/s to remove a tie rod end
Puller and hammer
200
What is used to flush old power steering from the system?
Solvent
Brake Fluid
Power Steering Fluid
Power Steering Fluid
200
Tech A says to adjust the caster to change SAI
Tech B says that the included angle of SAI adjustment is done with camber adjustment
WHO IS CORRECT?
Tech B
200
When installing ball joints, Tech A backs off the castle nut to align the cotter pin after torquing. Tech A says this will control binding. Tech B says the ball joint will eventually loosen and cause popping noises. Who's correct?
Tech B
200
Who is second in command at Camp Verde High School?
Mr. Benson
300
What makes the load-bearing ball joint, load-bearing?
The connection of the spring to its control arm
300
What holds on the wheel and tire?
Lug nuts and bolts
300
Tire Code Reads P225/60R16 97Z
Tech A says the Z is the tire speed rating
Tech B says different-sized tires on the rear will illuminate the yellow ABS MIL Light. Who's correct?
Both
300
Even at low speeds, a vehicle leans and has excessive body sway when turning. Which is the most likely cause?
1) Worn control arm bushings, 2) Worn idler arm, 3) Binding ball joint, 4) worn stabilizer bar bushings
Worn stabilizer bar bushings
300
When was the first high school built in Camp Verde?
1918
400
Name the parts of the conventional steering system
Box, Pitman Arm, Idler Arm, Outer and Inner Tie Rods, Center Link
400
What is the bounce jounce test for?
To test bump steer
400
The vehicle's steering wheel doesn't return to center after completing a turn.
Tech A says it's from a binding ball joint
Tech B says its from a loose tie rod end
WHO'S CORRECT?
Tech A
400
A vehicle with a ribbed serpentine belt chirps when started first thing in the morning. What is the least likely cause?
1) Worn serpentine belt, 2) Airated power steering fluid, 3) weak belt tensioner, 4) moisture
Airated power steering fluid
400
What's the largest high school in Arizona?
Hamilton
500
How do you adjust toe?
Outer tie rods
500
What determines the Ackerman Angle?
Angle of the steering arms
500
Component A helps dampen shock from bumps in road. TRUE. or FALSE
True
500
After adjustments are made, the technician adjusts the worm shaft bearing preload and sector shaft lash of a recirculating ball steering gear. The technician uses a
_______________ to check this.
Dial Gage
500
What's the most challenging high school in America?
Basis Oro Valley, Scottsdale (AZ)
US News and World Report named it as the 2nd best high school in America