Comp
Name a Dynamic Inspection Event
Tilt Test
Brake Test
Rain Test (EV)
Noise Test (IC)
The jacking point must be this color
Orange
An FSAE car must have 4 wheels that are not __________
in a line
All fasteners in these systems are required to be "Critical Fasteners" (name one)
Suspension
Steering
Brake
Accumulator Container mounting
Primary Structure/mounted parts (monocoque)
Any chassis tube attachments (if not welded)
AI Plate mounting
Scatter Shield mounting
Harness mounting
Type of liquid that EV motor coolant is allowed to be
Water (no additives)
Oil
Name something that will result in a point penalty
Not following an instruction directed at a team member
Failed protest
Late document submission
Failing to follow compsite vehicle movement rules
Extra person in Driver Change area (Endurance)
The smaller track width (front or rear) should be at least __% of the larger track width
75
Maximum number of electric motors allowed
Infinite, no limit
Threaded rod ends must be constrained with a ___ ___ to prevent loosening
Jam Nut
Vehicle number must be visible in these 3 locations
Front of the chassis and both sides of the chassis
A Driver must perform this test before they are approved to drive
There are this many cockpit cross section templates
2
This system is tested via an SAE official pushing on it as hard as they can
Brake Pedal
A "Critical Fastener" must have one of these driving types
Hex head
Hex recessed drive (Allen/Socket Head Cap)
The BSPD makes sure these two things don't happen at the same time
Braking and Power output
A vehicle is eligible to participate in FSAE competition when this system is newly manufactured from previously used car(s)
Chassis
All ____ components near the drivers legs need to be covered by shield of solid material(s)
Moving
Sharp
SAE has the right to impound any vehicle on competition site if/when ____ happens
literally nothing at all.
DAILY DOUBLE
A "Critical Fastener" must be of ________ grade or better
SAE Grade 5
Metric Class 8.8
AN/MS Specifications
Approved by Rules Question
2 parter!
The motor scatter shield must be made of this material and be of minimum __ mm thickness (answers in inches will be accepted)
6061-T6 Aluminum or Steel
1.0 mm (0.039 in)
3
The chain/sprocket scatter shield should cover the whole length between the ____ point of the front and rear sprocket respectively
Lowest
Teams will be expelled from comp if they do this off competition site
Drive the car
Name a "Positive Locking" Mechanism
Safety Wire (properly installed)
Cotter Pins
Nyloc Nuts (when < 80 deg) C
Prevailing Torque Lock Nut
These must not be made of any synthetic material that could melt in high heat
Driver's shirt, socks, undergarments