G-CODE (1)
A Rapid move G-Code
What is G00?
A CW arc G-Code
What is G02?
The G code that prepares the control to refer to the tool length compensation information page
What is G43?
The M code that calls for a tool change
What is M06?
The code used when cutting stock at a predetermined rate
What is the letter "F"?
Linear interpolation G-Code
What is G01?
Return to reference point G-Code
What is G28?
The G-Code that cancels a canned cycle
What is G80?
The M code used to start the spindle rotation CW
What is M03?
The code used to set the cutter rotation amount
What is the letter "S"?
Absolute positioning G-Code
What is G90?
The code used in peck drilling cycles
What is G83?
The G code that cancels cutter compensation
What is G40?
The M code that is used to end and rewind the program
What is M30?
Tool diameter selection code
What is the letter "D"?
Select work coordinate system 1 G-Code
What is G54?
A spot drill cycle G-Code
What is G82?
This G code turns on cutter compensation "Left"
What is G41?
A code used to stop the program
What is M00?
Code used to select the tool length offset selection
What is the letter "H"?
A CCW arc move G-Code
What is G03?
A tapping cycle G-Code
What is G84?
This code turns on cutter compensation "Right"
What is G42?
The code used to stop the program by which can be turned on and off
What is M01?
A code used in drill cycles to determine peck amount
What is the letter "Q"?