Electricity
How many paths of flow exist in a series circuit?
What is 1
These are non-regulatory information of interest to the aviation public?
What are advisory circulars
This is any substance that occupies space and has mass?
What is matter.
What type of cleaning agents should be used to remove grease, oil, or fuel from aircraft tires?
What is soap and water
One, two, and three-view drawings are commonly used to show what?
What is showing the shape of an object
What is a common cause of damage from the human body to solid-state components and/or integrated circuits?
What is ESD (electro-static discharge)
What is the frequency of release for new ADs?
What is bi-weekly
This is the energy of motion?
What is kinetic energy
Blistered paint surfaces or worm or thread-like tracks or patterns under the paint are visible signs of what?
What is filiform corrosion
This is a dimension allowable between parts?
What is clearance
What law governs the basic study of electricity?
What is OHMS Law
Where do you find the minimum scope and detail requirements that a 100-hour inspection checklist must contain?
What is FAR Part 43, Appendix D
Of the 3 states of matter, which state is affected most by thermal expansion?
What are gasses
These are the two general conditions that may cause stress corrosion cracking?
What are sustained tensile stresses and a corrosive environment.
What type of diagram would a mechanic use for troubleshooting?
What is schematic diagrams
This is the process by which small amounts of additives called impurities are added to the semiconductor material to increase their current flow by adding a few electrons or a few holes?
What is doping
An aircraft is considered large if the aircraft's maximum certified takeoff weight is over how many pounds?
What is 12,500 lbs.
What are the customary units used to express hydraulic or pneumatic pressure in the United States?
What is pounds per square inch
This should NOT be used on anodized aluminum surfaces because it will remove the oxide coat?
What is aluminum metal polish.
These are shown as solid lines broken at the midpoint for the insertion of measurements?
What are dimension lines
A parallel circuit has 100 volts applied, three resistors of equal value, and one ampere total current flow. What is the value of each resistor?
What is 300 ohms
After FAA Form 337 is completed, one signed copy goes to the aircraft owner and one copy goes where?
Where is the FAA.
What are the four principals forces acting on an airplane in flight?
What is lift, drag, thrust, and gravity.
This type of corrosion in aluminum can be readily identified by the appearance of corrosion products residue having a dark smoky or sooty appearance?
What is fretting corrosion.
These lines alternate long and short dashes?
What are center lines.