Thickness Planer
T/F
You should take 1/8" per pass
False
How much do you take off per pass?
1/16"
Name 3 ways you can support a long board when making your cut (200points each)
Other Person Holding
Table Extensions
Table or other stands
What is 3/4" as a decimal?
0.75"
This framing member stands alone and fits between the top and bottom plates
Common Stud
How many boards can go into our planer at a time?
1
T/F
You should only joint 1 face and 1 edge
True
True or False
You should start the mitre saw while resting the blade on your mark
False
How many 16ths are there in an inch
16
What is stronger? Screws or Nails
Nails
How do you clear wood chips under the planer?
With a push stick or long board
What is the max amount of passes it should take to straighten your board?
3
Always hold your board over the table using your _______ hand
Left
Reduce this measurement
14/16"
7/8"
Name the framing member that holds the weight of the header and all the weight above it (eg. other floors, the roof, snow)
Jack Studs
What is the minimum length of board?
12"
Push the board until the _________ closes
guard
Mitre saws make 3 types of cuts.
(400points each)
Cross cuts
Mitre cuts
Bevel Cuts
What is 3/8" + 1/4"
5/8"
What is the Canadian term for "Header"
Lintel
Always check for _________, _________ ,_________ before using the planer. (500 each)
Loose Knots
Nails
Grit
Never joint a ____________.
Edge, End, Face
End
When using a sliding mitre saw, you should finish your cut on the...
Push Back
Pull Forward
Push Back
If you want a wall to be 120" tall, and your plates are 1.5" each, what length of studs will you need?
115-1/2"
What are the 2 most common stud spacings in a regular framed wall
Bonus: What tool has both these measurements and can be used to do your layout
16" o/c
24" o/c
Bonus: Framing Square