Trenches/Service Laterals
Gas
Electric
AV
Tariffs
100
True/False - Natural Gas and Electric utilities are allowed to be in the same trench
What is True?
100
Pool/Spa Heaters are typically this many BTUs of input
What is 400?
100
PG&E Standard Residential provided Voltage in most areas
What is 240 Volts?
100
This is the maximum amount of business days allowed to clear the AVCC Task Code
What is 3?
100
This is the rule for description of Service
What is Rule 2?
200
True/False - Propane Gas and Electric utilities are allowed to be in the same trench
What is False?
200
True/False - Natural Gas is heavier than air
What is False?
200
The maximum span length of PG&E’s service drop to a temporary pole must not exceed ___ feet
What is 100'
200
This is an example of
What is a Single/One Line Diagram
200
This is the Rule governing Replacement of Overhead with Underground Electric Facilities
What is Rule 20?
300
The maximum height of a retaining wall over a gas service lateral
What is 3'?
300
The size/rating plate of this gas meter
What is a R275/275?
300
This is the minimum distance of operating room clearance in front of a pad mounted transformer door
What is 8'?
300
The amount of EV Chargers on a project that would route it to the EGI group instead of local
What is more than 4 (5 or more)?
300
This is the rule that governs for both electric and gas distribution or main extensions
What is 15?
400
The tool that's used to clear and prove conduits
What is a Mandrel?
400
.25 OR 1/4 PSI is equal to this many inches of water column measurement
What is 7"?
400
For electric distribution, low-voltage and high-voltage lines rated up to 60,000 volts, applicants must establish a 15-foot “low-growth” zone on both sides of all new lines. Applicants also must ensure that all branches with potential overhang within ________ feet of the conductors are trimmed.
What is 4?
400
The EA amount UC Berkeley would have to pay for relocating an underground electric service line to an office building
What is $2500?
400
The Rule governing Solar/Generating Facility Interconnection Projects
What is Rule 21?
500
PG&E Wire Conductor Installation
To minimize the possibility of cable damage during installation, the following design parameters must be followed:
1. The total number of factory bends installed in conduit run for primary cable must not exceed 300 degrees, including the bend at the feed-in location. Only factory bends are allowed.
2. The total number of factory bends installed in conduit runs for secondary cable and services having a maximum length of 200 feet must not exceed ___ degrees
What is 315?
500
This is the Maximum amount of Diversified BTU load an AL800 diaphragm Gas Meter can be installed for
What is a 1,120,000 BTUs
500
SCI - This is the minimum amount of service length coming from a 50kva TX to a 100A panel with 1/0A wire
What is 38'
500
This is the Maximum amount of Diversified BTU load an AL800 Gas Meter can be installed for
What is a 1,120,000 BTUs
500
These are the two rates for new streetlights that Express Connections Fresno can process
What are LS-1A and OL-1?