Bailey
Gabby
Katelyn
Tiffany
Rayven
100
The method of manufacturing shears whereby molten steel is poured into a mold and cooled is called
What is CASTING
100
The angle or degree at which a subsection of hair is held or elevated from the head when cutting
What is ANGLING
100
What will result if the head is not held in a constant position when cutting the back and side sections
What is AN UNEVEN CUT
100
When cutting a zero-degree, low-elevation or blunt cut, the hair
What is COMBED STRAIGHT DOWN AND CUT PARALLEL TO THE FLOOR
100
Layers create movement and volume in the hair by
What is RELEASING WEIGHT
200
When the scissor is held with the ring and little fingers of the opposite hand while the hair is combed
What is PALMING THE SHEAR
200
The guide that creates the line seen around the perimeter of the cut is called
What is EXTERIOR GIUDE
200
Always take consistent and clean ________ to ensure an even amount of hair in each subsection and produce more precise results
What is PARTINGS
200
The widest area of the head, starting at the temples and ending at the bottom of the crown, is known as
What is PARIELTAL RIDGE
200
When you comb the hair from its natural falling position, rather than straight out from the head
What is OVERDIRECTION
300
What is necessary to help control the hair and produce a more uniform cut
What is SECTIONING
300
If you cut one parting with light tension and the next parting with heavy tension, the results will be
What is POORLY BLENDED
300
The highest point of the head is known as
What is APEX
300
The level at which a blunt cut falls is called
What is WEIGHT LINE
300
The triangular section of hair that begins at the apex and ends at the front corners is known as
What is FRINGE
400
When the hair is parted from the center of the forehead to the center of the nape and then parted from the crown down to the ears
What is FOUR-SECTIONING
400
The angle or degree at which a subsection of hair is held or elevated from the head when cutting is called
What is ANGLING
400
A zero-degree elevation cut is known as
What is LOW ELEVATION
400
When the graduated shape, or wedge, has a stacked area around the exterior and is cut at low to medium elevations is known as
What is GRADUATION
400
Palming the shears during haircutting reduces strain on the index finger and _____ while combing the hair.
What is THUMB
500
The _______ of the hair will determine the size of the sub-section when cutting.
What is DENSITY
500
When hair is layered at a high elevation, what guide is used
What is INTERIOR GUIDE
500
A 180-degree elevation cut is also known as
What is LONG-LAYERED CUT
500
The process of removing excess bulk without shortening the length is called
What is TEXTURIZING
500
The implement used to create very short tapers quickly is the
What is CLIPPERS
M
e
n
u