Standards
What node should be used in a wave 3 Node+0
What is a NC4000H5
What is the highest acceptable tap value
What is 26/27
Should Circuit names use Underscores or dashes
What is dashes
What tab of Prism will find your walkout located
What is Documents
What is the default page size
What is A0
If an existing tap 1002 MHz level is 10db what drop type should be used.
What is HS_FUDGE
What cables must be replaced
What is smaller than .500
FWD 1 gets hooked up to what channel on the mux
What is CH20
Equipment is allowed to have a design build state if what kind of boundary is around it
What is active PID
What is splice #1 referring to on fiber after print
What is the node
Is NA/VL's allowed in non-greenfield areas
What is No
Existing Actives should be what build state in Magellan after HS
What is Upgrade
Pigtails are hooked directly to what
What is the node housing
If you are needing information about the walkout what type of hold should it be
What is incomplete survey
If a cable is upgraded, what must happen on the after print
What is highlight and callout
Should the NPS ( Node Portal System) be checked for every job?
What is Yes
How much reverse tilt (crossover) is acceptable
What is 2dB
What muxes are used for a dual fiber solution
what is 20-23 dwdm
You can find the conversion in what area in MQMS
What is MQMS Library
If fiber tracing doesn't go to the headend, what phrase should be placed?
What is Needs Audit
What market doesn't change their node names
What is Florida
If an EOL active is added the tap must pass at what level
What is standard
If new mux is located with a CDWM what wavelength on CWDM is to be used to overlay the DWDM
What is 1530 or 1550
When qcing errors should be located in what document
What is HS Standards
Should RES connections be highlighted on Splice 2 tab of the MOP
What is No