Zig not Zag
This is the frequency Zigbee uses.
What is 2.4Ghz?
This is an entry point to a home that should almost always never have a delay.
What are windows?
This is the resolution of the Icam 2.
What is 720p?
This is how a PRM is defaulted.
what is holding the tamper button and powering up the PRM, then releasing the button after the pairing led lights up?
Every sensor on a hard wired panel functions as a basic ______ at the panel.
What is a switch?
LQI is the Link Quality Index which can not be below this number in order to perform firmware updates to a zigbee device.
What is 236?
This is what you should do to a motion before you go to test a system or add it to a PRM.
What is cover a motion?
This is the resolution of an Xcam2.
What is 1080p
This is where you go to verify HVAC system compatibility and programming codes.
What is the zen thermostats website?
We use this to allow a customer to use a legacy alarm system but still upgrade to our Homelife Platform.
What is a PRM?
This number is the lowest acceptable RSSI.
what is -85db?
This is the delay time it takes a perimeter device to trigger an alarm in any arming mode.
What is no delay?
This Camera Has 2 way audio.
What is the Xcam2?
This is 1st step before installing a PRM or thermostat.
What is verifying the previous system works?
This is the zone all two wired smokes need to be tied to on both a PRM and a panel.
What is zone 1?
These can be used to repeat zigbee in our security system, still pass firmware, and even have a battery backup.
What are PIMs, PRMs, and the CHL nightlight(siren repeaters do exist in the wild)?
Motion sensors can detect motion at up to this distance while ignore pets of up this this weight.
What is 49ft and 85lbs?
Viewing angle of the Icam 2 is this number.
what is 120 degrees?
This is where I go to get a premise passphrase to delete any security or life safety devices.
What is CXC under the CPE section or calling into tech support if you have no data connection?
Four wired smokes are hooked up on a Prm to these locations.
What is smoke power and any zone but 1
This is the MAX range of zigbee not accounting for interference.
What is 33ft -246ft?
Glass breaks work up to this distance with clear line of sight.
what is 20'
The distance we can run ethernet to power an Icam2 is _________ft.
What is 100?
This is how you default a touch screen.
What is going to the setting, then advance, then factory default the screen entering your premise pass phrase?
This is the step you must do when adding a PRM right before you can label any zones.
What is tapping zone 1 and choosing if it need to be powered for smokes?