Safety
When referring to the correct use of a fire extinguisher, the acronym "P.A.S.S." stands for
Pull, aim, squeeze and sweep
This is the term used to describe heat removal and release
Refrigeration
The ability to motivate others is an example of this
Leadership
This is used to grip pipes and other cylindrical surfaces
Pipe wrench
Heat is this
a form of energy or the speed of molecular motion
The term "OSHA" stands for
Occupational Safety and Health Administration
These are the four basic components of any refrigeration system
Compressor, Condenser coil, Metering device, and Evaporator coil
The work of an HVACR technician is divided into these two categories
Installation work and service work
A hex key wrench is more commonly known as this
Allen wrench
The definition of a BTU is this
the amount of heat required to raise the temperature of one pound of water 1 degree Fahrenheit
A body that becomes part of an electric circuit is undergoing this
shock
These are the two sides of the refrigeration system
high pressure side and low pressure side
Involvement in HVACR-related organizations provides an opportunity for new technicians to begin this
Networking
Enlarging the inside diameter of the end of a piece of tubing to join it to another piece of the same diameter is referred to as this
Swaging
Solids, liquids, and gases exert forces these three ways
downward, outward and downward, and in all directions
This is used when using a torch near combustible materials
Heat shield
The boiling point of the refrigerant in a refrigeration system depends on this
Pressure applied to it
When preparing for an interview, you should always do at least these three things
Research the company, prepare a list of questions, and arrive a few minutes early
The two most important tools in your toolkit are these
Refrigeration gauge manifold and multimeter
The weight of a one square inch column of air on the earth is known as this
Atmospheric pressure
This component shuts the furnace off in the event of over-heating
High Temperature limit
What two conditions are necessary for heat absorption in the evaporator?
Low pressure and the presence of liquid refrigerant
All persons who intend to install, maintain, service, or repair HVACR equipment should first acquire this
EPA certification
Name five types of pliers
Slip- joint, tongue and groove, lineman's, diagonal, needlenose, long nose, curved long nose, grip, etc.
The only temperature that is the same in both the Fahrenheit and Celsius scales is this one
-40 degrees