A ton of refrigeration
What is 12,000 BTUs / hour?
Compressors cause this to force the flow of refrigerant.
What is a pressure differential?
Identified by their grey tanks and yellow shoulders
What is a recovery tank?
If there is an internal failure, it cannot be repaired.
What is Hermetic Compressor?
What is an evaporator coil?
Heat added to a vapor after a change of state...
What is superheat?
How refrigerant leaves the compressor
What is high-temperature, High-pressure vapor?
Will tell you how much liquid you have in your outdoor coil...
What is subcool?
Creates an intentional restriction in the refrigerant circuit
What is a Metering Device? (will accept TXV)
A possible reason your system is tripping on high limit
What is a plugged condenser coil?
Increases and decreases with the pressure...
What is Saturation Temperature? (would also accept temperature)
Once through the metering device, the refrigerant is this mix of liquid and gas.
What is 80/20?
The most accurate way to charge refrigerant
Responsible for adjusting your metering device based on temperature of your lineset.
What is a sensing bulb?
The first thing to check when you have ice over your evaporator coil
What is airflow / static pressure? (will accept filter)
The recommended CFM setting for the following:
What is 1200 CFM?
This remains constant in the evaporator until all refrigerant has changed state.
What is temperature?
The measurements needed to determine target superheat
What are indoor wetbulb and condenser dry bulb?
The compressor winding that should read the largest resistance
What is Start to Run?
Used to make the coils change jobs
What is a reversing valve?
14°C, but in America
What is 57.2°F?
This is when subcooling begins
What is when all refrigerant is condensed into a liquid?
This refrigerant is NOT compatible with copper tubing.
What is Ammonia?
Indicated by power going to the compressor, but no change in refrigerant pressures
What is broken scroll plate / crank shaft?
A type of coil developed to eliminate standard round copper or aluminum tubing.
What are microchannel coils?