Fluids
Componets
FAP/VAD
Pneumatics
Valves
1

A good hydraulic fluid, that has chemical stability, also has these 3 characteristics.

What is low viscosity, high flashpoint, and high firepoint. 

1

This creates the flow of hydraulic fluid throughout the system?

What is a pump. 

1

This states pressure exerted anywhere in a confined incompressible fluid is transmitted equally in all directions?

What is Pascal's Law.

1

After a component is actuated, the air is returned here?

What is dumped overboard. 

1

This is a unit which causes one hydraulic operation to follow another in a definite order?

What is a sequence valve. 

2

Neoprene and Buna-N seals are used with this type of fluid base.

What is mineral based.

2

This component holds a preset pressure on the system?

What is an accumulator. 

2

Force is found by doing this to these two factors?

What is multiplying pressure and area. 

2

This is a chemical used in taking moisture out of the air?

What is desiccant. 

2

This type of valve in an aircraft hydraulic system permits fluid to flow freely in one direction, but restricts the rate at which fluid is allowed to flow in the other direction?

What is an orifice check valve. 

3

In regards to temperature, this is one of the main advantages of Skydrol?

What is a wide operating temperature.

3

This part of the reservoir is in place to reserve fluid for the emergency systems?

What is a standpipe.

3

This is a constant on a hydraulic system?

What is pressure.

3

Unlike hydraulic systems, all pneumatic systems use one of these components as a damage preventing unit?

What is a relief valve. 

3

The component in the hydraulic system is used to direct the flow of fluid is the?

What is a selector valve. 

4

Blue color, vegetable base, will burn, natural rubber seals are characteristics of this mil- spec?

What is Mil-H-7644.

4

This converts hydraulic energy into mechanical energy?

What is a hydraulic motor. 

4

This is found by multiplying the area of the piston by the distance traveled?

What is volume. 

4

This is required in an aircraft pneumatic system which incorporates an engine-driven multistage reciprocating compressor?

What is a moisture separator.

4

This valve installed in a hydraulic system will have the highest pressure setting?

What is a thermal relief valve. 

5

This seal/material is used with phosphate ester base hydraulic fluids?

What is Butyl rubber.

5

This transforms energy, in the form of fluid pressure, into mechanical force and is only capable of producing powered movement in one direction?

What is a single action actuator. 

5

This is measured in cubic inches?

What is volume. 

5

This regulates the compressor inlet air to provide a stabilized source of air for the compressor?

What is an absolute pressure regulator. 

5

This type of selector valve is one of the most commonly used in hydraulic systems to provide for simultaneous flow of fluid into and out of a connected actuating unit?

What is a four port, closed center selector valve?

M
e
n
u