I like to Move It! Move It!
G01
What is Linear interpolation (Movement Command)?
BONUS:
What other code is used in the same block(line) to designate feed rate?
M03
What is CW spindle rotation?
BONUS:
What other code is used in the same block(line) that specifies spindle speed?
G20
What is imperial unit of measure?
M30
What is end of program with rewind?
M08
What is flood coolant on?
M6
What is tool change?
G02
What is CW Circular Interpolation (Movement Command)?
BONUS:
What other codes are required on the same block(line); used to define the arc (2 possible answers)?
M04
What is CCW spindle rotation?
G17
What is XY plane selection?
M00
What is compulsory program stop?
H__
What is the command that specifies the tool length offset?
G28
What is send to machine home with intermediate point?
G03
What is CCW Circular Interpolation (Movement Command)?
M05
What is spindle rotation stop?
G90
What is Absolute positioning?
M01
What is optional program stop?
D__
What is the command that specifies the tool diameter offset?
G53
What is machine coordinate system?
G00
What is rapid linear interpolation?
SEND IT!!!!
M19
What is orient spindle?
G80
What is canned cycle cancel?
M98
What is sub program call?
G41
What turns on cutter compensation left ?
What is initial point return for canned cycles?
G04
What is a Dwell Command?
BONUS:
What other code is required in in the same block(line)? What does it define?
M88
What is through-spindle coolant on?
G49
What is tool length offset cancel?
M02
What is end of program (no rewind)?
G43
What cancels cutter compensation?
L__
What is number of repeats?