Security
This protocol should be used instead of Telnet for security reasons.
What is SSH?
Stateless DHCPv6 does not give this type of information out to end devices.
What is addressing?
Name one of the benefits of EtherChannel.
What is: Bandwidth and/or Redundancy
The reason STP was invented was to prevent this.
An FTP server would use these two port numbers.
What are ports 20/21?
This type of attack would cause end devices to be unable to obtain an IP address.
What is DHCP starvation?
Stateless DHCPv6 has these M and O flags.
What is M = 0, O = 1?
This mode forces an interface to become an etherchannel, regardless of which protocol is being used.
What is ON?
The root bridge will be decided by this value.
Convert from binary to decimal: 01000101
Oh no! Frames are being flooded out every port in the VLAN! This type of table-filling attack may have caused this.
What is MAC flooding?
Name the four stateful DHCPv6 message types in order.
What are: Solicit, Advertise, Request, Reply?
STP would see an etherchannel connection as this many logical connections.
What is one?
A root and designated port would be in this port state.
What is forwarding?
RIP only takes this value into account when calculating cost.
What is hop count?
This port security mode will drop all unknown frames, but do nothing else.
What is protect?
For Stateful DHCPv6, this command must be entered on a client interface in conjunction with the link-local or global-unicast address of the DHCP server.
What is ipv6 dhcp relay?
Link Aggregation Control Protocol (LACP) uses these two modes when configuring an etherchannel link.
What are active and passive?
This value is used to decide if a port becomes a root port.
What is path cost?
Network Address Translation exists in IPv6 for this reason.
What is IPv4 to IPv6 migration?
BPDU Guard is enabled on this type of interface in order to stop unwanted switches from entering the network.
What are end user interfaces?
SLAAC is used on a network and a default gateway has been selected using this type of address from the router interface.
List two out of the three things that need to be identical in order for an etherchannel link to be formed.
What are: Link speed, duplex mode, and VLANs?
This confreg value will cause a router to ignore its startup configuration, useful for password recovery.
What is 0x2142?