FOC
Installation
Documentation
Routing
Misc
100

This allows for the “A side” and “B side” test sets to communicate, enabling bi-directional long shot, talk set, and remote screen functionality.

Datalink

100

Gold's standard for power colors 

Red = battery, black = return

100

This is done at every site, for every deployment, unless specified otherwise per the customer. 

Photos!

100

This is one of the two most common link state database routing protocols

OSPF or IS-IS

100

Location of Hattie B’s

Nashville, TN

200

This test uses an optical light source and a power meter to measure the span loss independent of the OTDR/AP results

FCOMP

200

This is the pattern of a straight thru cat5

1. White Orange  2. Orange  3. White Green  4. Blue  5. White Blue  6. Green  7. White Brown  8. Brown 

200

An EDP that has been edited by the engineer and is used for documentation to produce the As-Built

Redlines 

200

This is what MPLS stands for

Multi-Protocol Label Switching

200

A LightRiver initiative to showcase multivendor interoparability. Any transponder on any line system. 

Alien Aware 

300

A negative loss

Gainer

300

For Gold, anything that plugs into the "SW" management devices main ports using this color cat5

Yellow

300

FOC Summary Sheet that Gold uses

OIL Report

300

LSP stands for this

Label Switched Path

300

Capable of distinguishing wavelengths without crosstalk. The technical requirement is only that the lasers be of very specific wavelengths nad the wavelengths stable. Current systems offer 4-40+ channels of wavelength. 

DWDM

400

Passive device that allows a specified range of wavelengths to pass through while blocking/attenuating anything outside of that range. This device make it possible to OTDR fiber that has OSC light on it from a previously-installed site.

Band Pass Filter

400

A temporary Optical Channel used to validate route continuity during Amp Chain Installation

Pilot Wave

400

The standard documentation process order

 SS>EDP>RL>AB

400

Routers use their link state databases to build this

Routing table

400

100G channelized modulation scheme

PAM4

500

Standard singlemode fiber cable has a pronounced attenuation increase at 1383 nm. This region is an area within the fiber’s transmission spectrum where light is increasingly absorbed by the hydroxyl (OH-) ions present within the structure of the glass core.

Water Peak

500

This is the 1830 DB9 Adapter Pin Out

Pin-2 Yellow

Pin-3 Black

Pin-5 Red

500

The newest section added to the EDP

Test Recordings

500

Every router participating in the routing protocol has a link state database. This is the difference between these databases

They are exactly the same on each router

500

This method of 6500 troubleshooting is most commonly used when a portion of the provisioning that cannot be undone easily must be changed otherwise. This should only be done as a last resort. 

LABSLAT

M
e
n
u