Table Saw
Always keep the ______ in position.
What is the Fence?
PLANER
Always place face down on planer (cuts ______ of board).
What is the top?
BAND SAW
Never place fingers under the ________.
What is the guard?
What must be worn at all times?
What are safety glasses?
what is the number 1 rule?
What is have a good positive attitude?
Stand ________, never directly behind the blade.
What is to the side?
JOINTER
Never use it without a _______ in place.
What is the guard?
DRILL PRESS
Do not touch the ________ after drilling holes
What is the drill bit?
What is a class A fire?
What is paper, wood, cloth?
What do you do in the event of a small cut?
What is allow it to bleed, then wash and put on a band aid?
Keep hands at least ______” away from the blade
What is 6?
JOINTER
Never allow fingers to hang ________ the top surface of the board.
What is below?
BAND SAW
The bandsaw can perform these types of cuts?
What are any? (Rip, Cross cut, angle, curve)
What is a Class B fire?
What is oil/ grease?
What do you do in the event of a splinter?
what is notify instructor, use tweezers, band aid?
MITER SAW
Be sure to have a ______ edge against the fence
What is Joined?
PLANER
Never plane warped boards until one surface had been trued on the _________.
What is the jointer?
DRILL PRESS
be sure there is _______ ________ under your board before drilling
What is scrap wood?
What is a class C fire?
What is Electrical?
what do you do in the event of a burn?
What is, run under cold water, add burn cream, band aid?
Always use a _____ __________ to remove all small cutoffs from the blade area.
What is a push stick?
JOINTER
Join _________ face of board first.
What is the concave?
BAND SAW
NEVER cut _______ wood on the band saw
What is round?
Where should nails and screws never be?
What is mouth or pockets?
what do you do in the event of an eye obstruction
What is flush it with the eye wash, Do Not Rub it!