Tools
Can you ever not use push sticks on the jointer?
Yes, only when material is above the fence
You should never leave a machine until you do what?
Turn off the machine and wait for the blade to come to a stop.
What should you use to move cut offs away from the blade, when working on a machine
push stick
Is rough housing or chasing others acceptable in the workshop?
No
What tool should you have your fingers 3" back from the blade?
Band Saw
If you feed a board into the thickness planer and it gets stuck, can you lower the table to help it through?
No, only after you have turned the machine off and the blade has stopped moving
You should never _______ material into the machines, let them cut at their own pace.
Force / feed aggressively
If material is too small to hold onto safely what are 2 options you can use?
Clamps, push sticks, or scrap material
What does ripping a board refer to? (making a rip cut)
Cutting material with the grain
To use the jointer, thickness planer, table saw, and chop saw what is the minimum length of material required?
12" or 1'
what is the purpose of the jointer?
To mill a flat face and/or square and edge of wood
Always make sure material is _______.
Clean and free from debris
you should always know where the _____ is on every machine.
ON/Off, Emergency stop
What does PPE stand for? and what are the 2 pieces of PPE that we must wear in the classroom?
Personal Protective Equipment
Safety glasses, and hearing protection
When using the jointer and thickness planer you should only take a maximum of _____ per pass
1/16"
Name the tool that is used to rip and cross-cut wood to specified sizes and angles.
Table saw
If a tool is damaged or broken you should?
Report it to Mr. Allen
When using the drill press you should always place material where on the table?
Left side of the machine
What is the minimum thickness of material being fed through the thickness planer?
3/8"
When using the drum sander you should only take a maximum of _____ per pass
1/32"
Name the machine that has a material hold down arm
Scroll saw
You should always do what while the machine is off?
Make adjustments to the tool.
When using the Scroll saw or band saw, what should you do to back out of a cut?
Stop the machine, wait for the blade to stop moving, then back the blade out
Name the 6 hazards we mentioned in class
Dust, Cutter, Entanglement, Noise, Flying debris, Kick back
How high should the band saw's blade guard be above your material? (measurement)
1/4" (pencil width)