Scroll Saw
When pushing the work through, do not _____ the piece.
Force
Push stick
If the board you are cutting has a bow in it, place _____ side towards the fence.
convex
Always clear away _____ and _____ with a brush, not your hands.
Chips and dust
Turn on the ____ ________ before using the edge sander!
Dust collector
Never pull or force a jammed piece through the equipment. Shut the power off and carefully ________ the piece.
Dislodge
If a finger can pass between the top of your workpiece and the bottom of the upper guide rollers, the guard is too ____.
High
Your body should be slightly ____ of the machine.
Left
Remove the _____ ____ before starting the drill press.
Chuck Key
Remove all _______ from the sander and floor before and after sanding.
Sawdust
Remove _____ ______ from the table only after the blade has stopped.
Scrap pieces
Keep your hands _____ or ______ the blade.
Beside or behind
Do not cut anything less than _ inches long.
6
Close the ______ ________ before starting the drill press.
Guard window
Ensure the sandpaper belt is in good ______ and not torn or ripped before use.
Condition
Always operate the saw from the front and never from the ____.
Side
Do not back out of the cut with the ______ on.
Power
Never operate the saw with your arms _______.
Crossed
The speed of the drill press is important - The ______ the bit, the slower it should be spinning.
Larger
Do not sand _____ parts on this machine. Sand those by hand!
Small
No _____ clothing, long hair, or jewellery is allowed while operating the scroll saw.
Loose.
If a blade _____, immediately back away from the machine and tell Mr. Burt.
Breaks
Do not cut your piece if it is not completely ____ against the fence.
Flat
Allow the machine to reach _____ ______ before starting your cut.
Full Speed
Never leave this machine _______ while running.
Unattended