planer
Before operating a planer, articles of clothing such as ties and coats, should be:
removed
When operating the drill press, what should be done with long hair?
tie it close to your head and keep your head away from moving parts
When sawing small stock, you should always use a
push stick
An 6 inch jointer has knives that are _______ inches long.
How must the saw blade be held after the cut is finished and before the blade stops rotating?
hold it in the down position
The purpose of the off-bearer when using the planer is to __________
support, pull, and move with the stock as it comes through the planer
What type of drill press chuck should be used with a straight shank twist drill?
Jacobs chuck
While operating the band saw, it is a safe practice to
to maintain a balanced stance at all times
Maximum cut for a face is _____________.
1/16
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
clamp the stock to the table
How many boards can be fed safely through the planer at one time?
1
Which item of protective equipment is absolutely necessary when operating the drill press?
safety glasses
If you hear or feel a rhythmic click as the wood is being cut, this usually indicates that:
blade is cracked
The infeed table is ______________ to increase the cut.
lowered
When is it safe to remove wood scraps from the cutting zone?
while the saw is off and hand is not on the off/on trigger
Which item(s) should not be worn when operating the planer
If the stock being drilled begins to revolve, you should
turn off the drill press and free the stock
If too much cutting pressure has to be applied to make a cut, the blade
is dull
The jointer size is determined by the length of the
knives
Hands or fingers should never come closer than ___________ inches to the rotating blade when operating the motorized miter saw
6
Which type of stock should never be run through the planer?
painted stock, green stock, over dried stock, and extra long stock
To select the proper drill bit, one should check
size, sharpness, and type of shank
The best time to remove scrap material from the band saw is
when the saw stops
Always use the _______________ when jointing a face.
push block
Besides safety glasses and closed toed shoes, what personal protective equipment should be worn when operating the motorized miter saw?
hearing protection