Electrical
Suspension
Steering
Engine
Braking
100
Voltage should be present on the ground
True or Flase?
False
100
What are the 4 types of ball joints?
Guiding ball joints, Load carrying ball joint, Tension ball joint, Compression ball joint.
100
When Overhauling a reciprocating ball steering gear, what order are the adjustments made?
Warm-Bearing preload, then sector-shaft over center
100
An engine block should be mounted to an engine stand using a minimum of _________ Bolts, and what grade?
4 Bolts, Grade 5 and above
100
What is the purpose of the master cylinder
Generate hydraulic pressure needed to apply the brake mechanisms.
200
what is the first step when removing an old battery?
Disconnect the negative cable.
200
What peice of equipment has been added to the single pivot control arm to help with stability?
Strut rod
200
what are the different steering types?
Rack and pinion
parallelogram
steer by wire
Four wheel steering
200
what are the four strokes of an engine?
suck squeeze bang blow
intake compress power exhaust
200
Residual pressure in the brake lines is maintained by what?
Master cylinder compensating port
300
Draw a regular Diode!
300
What is a Dead axle vs Live axle?
Dead Axle- Does not power wheels
Live axle- Connected to drive train to power wheels
300
What type of power assist unit uses pressure developed by an external pump, such as the power steering pump?
(4 Answers)
Hydraulic assist, Vacuum assist, ABS, ASC
300
What is James favourite word and why?
N*****
Beats me ;)
300
What percentage og braking is done with the front tires ?
80%
400
If silicon is doped using a material which has 3 electrons in it’s valance ring, what is the result?
A positive (P type) material
400
______________ camber is when the top of the wheel is outward compared to the
lower axis when viewed from the front. This will cause the tire to wear on
the outside edge of the tread
Positive
400
What action takes place in the operation at high speeds of a Quadrasteer steering system?
At high speeds, the rear wheels turn in the same direction as the front wheels.
400
Cam shaft is responsible for?
For opening and closing the intake and exhaust valves.
400
What indicates a wheel cylinder leak?
3 answers
(1) Fluid can be found
when the dust boot is
peeled back;
(2) the cylinder, linings,
and backing plate, or
the inside of a tire might
be wet; or
(3) there might be a drop
in the level of fluid in the
master cylinder reservoir.
500
Draw an NPN transistor diode!
500
_____________ Angle – has the thrust line aimed to the Right.
_____________ Angle - has the thrust line aimed to the left.
Positive Thrust Angle – has the thrust line aimed to the right.
Negative Thrust Angle - has the thrust line aimed to the left
500
The worm gear and the pitman gear are components within a recirculating ball steering gearbox.
True or Flase
True
500
Main bearing clearance specification 0.002 thousandths of an inch. is this acceptable?
acceptable
500
What is the difference between a Fixed caliper and a floating caliper?
Fixed caliper-Stationary set of pistons, even distribution of pressure on the breakpads
Floating caliper- not directly connected to wheel hub or axle , moves in relation to the rotor, used in high performance vehicles