AP-001
AP-003
AP-004
AP-007
AP-011
100
Is the National Gas Outlet thread shown on this print right handed or left handed?
What is Left-Handed
100
What type of section is shown in Section B?
What is half section?
100
Within what zone is the primary portion of View A?
What is B7?
100
One of the views features four circles and a set of center lines. What terms apply to the relationship the four circles have with each other?
What is concentric?
100
What is the surface texture specification for the cylindrical surface that has a diameter of 31.7–31.8?
What is 8 micrometers?
200
What is the smallest thread pitch specified on this print?
What is 1/20
200
What does UNEF stand for in the thread note on this print?
What is Unified Extra Fine?
200
This assembly drawing includes a threaded stud. By what method are the threads represented?
What is Simplified?
200
How many auxiliary views are found on this print?
What is one?
200
What method of thread representation is used on this print?
What is schematic?
300
What type of line is used to indicate the circular area being enlarged for View A?
What is phantom?
300
In how many of the four main views are section lines used?
What is 2?
300
For the two holes identified as datum D, what is the total size tolerance specified for those holes?
What is 0.006"
300
How many reference dimensions are specified on this print?
What is three?
300
What is the smoothest surface texture specified on this print?
What is 3.2 micrometers?
400
What size paper was used for the original version of this print?
What is B?
400
In detail A, the angular measurements are given in degrees and minutes. How much tolerance is specified for the angles?
What is 1°?
400
List the three parts indicated by name in the parts list.
What are Bracket, Insert, and Stud?
400
How many cutting-plane lines are shown on this print?
What is two?
400
Is datum D established as a plane or an axis?
What is axis?
500
Give the diameter of the countersink leading into the largest threaded hole.
What is 0.906"?
500
For the overall diameter dimension, what name is given to the tolerancing method used?
What is Plus or Minus Dimensioning Method?
500
Based on the shape of cutting-plane line, what type of section is Section B-B?
What is Offset Section?
500
Carefully examine the drawing. With respect to the enlarged Detail C, how many times larger is it than the other multiview views?
What is five?
500
This part features a V-groove for a belt. What term applies to the included angle of the V-groove: acute, obtuse, right, or oblique?
What is acute?
M
e
n
u