Lock-Out/Tag-Out
Device used during a group lockout to offer everyone participating in the lockout the same level of protection.
What is a lockbox?
Always do this when you are carrying a load that obstructs your vision.
What is driving in reverse?
Quarterly inspection to ensure that all e-stops, pull cords, light curtains, and interlocks are in working condition.
What is the verification of safety devices?
You should do this before using a ladder for the first time during a shift.
What is a ladder inspection?
The most injured body part in our industry.
What are the hands?
Procedure used during situations where it is required for certain parts of the machine to remain energized.
What is ESP/Energy Safe Procedure?
A process verifies a PIT is in good working condition before use.
What is a pre-shift inspection?
The term for getting caught, pinched, or pulled in by a piece of equipment.
What is entanglement?
This should be maintained at all times when climbing or using a ladder.
What is 3 points of contact?
A device used to support lifesaving measures when a cardiac emergency occurs.
What is an AED?
This is the most critical step of the lockout tagout process.
What is verification?
Two procedures that pedestrians must follow while being present in high PIT traffic areas.
What are wearing a vest and calling out?
The area on a machine where work is performed.
What is the point of operation?
This should be used in combination with a harness when using the genie lift.
What is a SRL (Self Retracting Lifeline)?
She is the South Region health and safety leader.
Who is Linda Bruce?
A status is required to be held by any individual that performs or participates in a lockout.
What is authorized?
The component of the PIT that prevents the lift from tipping over when picking up loads.
What is the counterweight?
A type of machine hazard that deals with machine movement NOT at the point of operation. Hint: hazards regarding the point of operation are considered "hazardous actions".
What is a hazardous motion?
The OSHA height requirement that triggers the need for fall protection in a manufacturing setting.
What is 4 feet/48 inches?
The state level organization that regulates most of the environmental rules and standards that we follow.
What is the DEP?
The five types of hazardous energy found in our plant.
What are electrical, pneumatic, steam, water, and gas?
Geometric property that should be accounted for whenever you perform actions that may effect the PIT's stability such as stacking or turning with a load.
What is the center of gravity?
Three of the six requirements of an adequate machine guard.
What is: Prevent contact, Be secure, Create no new hazards, Create no interference, Allow for safe lubrication and/or Protect from falling or flying objects?
A harness component that should be utilized to keep blood flowing to the legs if a fall occurs while wearing a harness.
What are stirrup packs?
Our EBITDA number (% or $ amount) for March 2026.
What is 18% or $372,000?