Random 1
Random 2
Random 3
Random 4
Random 5
100
In the MH-60"R", What component uses fuel as a DIELECTRIC?
Fuel Probe
100
DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE JEOPARDY!!!
How is the low level sensor alligned during installation?
100
In the "S", on what side(s) is(are) the gravity port(s) located at?
Both PORT and STBD
100
On the "R", how many connectors does the Fuel Management Control Panel?
Two
100
Where are the Extended Range Ful Cells installed?
Cargo compartment
200
on the "R", where are the Fuel Selector Levers located?
Engine control quadrant
200
In what manual and work package can you find the PURPOSE of the MH-60R Fuel Quantity System?
460-100 WP 6
200
DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE JEOPARDY!!!
When is the dry cal mandatory?
200
On the "S", What circuit breaker supplies power to the Fuel TEST Switch?
CB 154
200
On the "R", what is the rate of XFR in gallons/minute?
120 Gal/min
300
What is the capacity of a "R" Aux Tank?
735 lbs or 113 gal
300
When performing Fuel Dump Checks on a "S", how many gallons must the container's capacity be?
At least 50 gal
300
On the "S", what is the minimum size container used to catch residual fuel when changing the BOOST Pump?
3 gallon
300
on the "S", at what PSID (pressure) does the fuel stop flowing during Helicopter In-Flight Refueling (HIFR)?
20-30 psid
300
Where is the OVERFLOW sensor located on the MH-60S?
On the overflow vent line
400
On the "R", what component is mounted in-line behind the HIFR nipple? (This component allows filter fuel to pass)
The go-no-go gauge
400
In the "S", how tight do the GAMAH nuts get tightened when installing the Fuel Dump Sensor?
Handtight
400
DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE JEOPARDY!!!!!
What is the maximum resistnace allowed when performing bonding checks after installing the AUX FUEL SIGNAL CONDITIONER on the "S""?
400
In the "S", what must be pulled down before moving the engine control levers to LOCKOUT?
Rotor break interlock tabs
500
According to the "R" Fuel dump SCHEMATIC, what bus and circuit breaker powers the #1 fuel dump/xfr pump?
No. 1 AC Primary bus and CB-403
500
According to the "S" fuel boost pump system schematic, What kind of voltage is present on connector P378 pin H?
No voltage, pin H is a ground
500
On the "S", What componet connects to reference designator P317?
Fuel Quantity Signal Conditioner
500
According to the "R" low level warning schematic, what does actuating switch S2 do?
Provides a ground for relay K2
500
According to the "S" low lever warning schematic, what component provides a groind for the relay K2 on the Miscellaneous Switch Control Panel>
Fuel Test Switch S2
M
e
n
u