1
On the miter saw, material should be held firmly against the base as well as what
What is the fence
Hands should never be closer than how many inches from the blade on the table saw
Metal or wood chips should be removed from the drill press by using what
What is a brush
On the miter saw, where should the saw blade be aligned when making a cut with the motorized miter saw
What is the waste side of the marked line
What should be done with articles of clothing such as ties, coats, and long sleeves when operating the table saw
Once a rip cut is started on a table saw, where should the operator put forward pressure on the piece being cut
What is on the piece between the fence and the blade
Where should the saw blade be positioned when cutting is completed and the operator is leaving the work zone?
What is locked down?
What needs to be done before replacing nails in the nail gun
What is remove the battery or disconnect the power source
What type of stock should never be ripped on the table saw
What is round stock
What are two things that are unsafe to do with a jig saw
What are changing the blades or adusting the saw without removing the batter or power source, backing the saw out of the while the blade is in motion, making sharp turns that cause the blade to flex or twist, or to start the blade while touching the material you are going to cut
To prevent slipping and falling when using the table saw do not do what
What is over-reach when feeding material through the saw
Which item of protective equipment is absolutely necessary when operating the drill press
What are safety glasses
When is it safe to remove scraps from the cutting zone of the miter saw?
What is when the saw is off and the your hand is not on the off/on switch
Applying to much force while using a drill could cause what problem
What is damage the drill, break the bit, or cause it to slip and injure you
An area where a person's body part can be caught between a moving machine part and a stationary object, or between two moving parts is called what
What is a pinch point
When sanding, let the sander do the work which means avoiding excessive what
What is pressure
Where should the operator stand while cutting with the table saw
What is to the side, not in line with the blade
When making a rip or crosscut the saw blade on the table saw should extend no more that how many inches above the stock being cut
What is 1/4"
The arbor nut holding a saw blade on the table saw is only tigntened when what is disconnected
What is the saw is unplugged or the electrical service is disconnected at the circuit breaker
On the miter saw, hands or fingers should never be closer than how many inches to the rotating blade
What is 4 inches?
On the miter saw, after a cut is made what must be done next until the blade stops turning
What is hold it in the down position
On the miter saw, how can the saw operator prevent the blade from binding when cutting warped, bowed or long wood
What is clamp the wood to the saw base and support the long end
To prevent a kickback when ripping material on the table saw, you should do what
What is keep the material firmly in contact with the table and the fence
To prevent seizing on the drill press, one should do what when the hold is almost through
What is reduce feed pressure
A miter cut is only permitted on the table saw when using what
What is a miter sled or miter gauge