1
2
3
4
5
100
A________ end mill that can be fed into the work like a drill.
two flute
100
these thing must be done before you mount work in a vise.
wipe vise base and worktable, and expect for nicks and burr.
100
Measurements of the ________ are made with the blank size and shape tooth thickness and depth
What is bevel gear
100
These three ways are ways to machine an angle
What is Setting the work in the vise in the required angle, tilt the spindle head to the required angle, use a fixture
100
__________is a machine opperation that is performed with a "slitting saw" and gets better results if using the climb milling method.
What is Slitting
200
These tools are used to find hole on the work on a milling machine
What is an edge finder, wiggler, Scoope
200
These cutters can only be used on milling machine so that the cutting pressure forces it towards the column.
What is a helitical slab cutter
200
they are used to change the angular direction of power between shafts
What is a bevel gear
200
When making gears the cutter is close to the _______ and the cutter travel towards the _______ ______
What is work and dividing head.
200
Slitting and Sloting differ in when ______ cuts are made partway through the work
What is slotting
300
A _______ _____ on a milling machine can be used to align the vise with the milling machine.
What is Vienier Head
300
When maching a flat surface on a horizontal milling machine use the ______ ____ that smaller than the joe
What is shortest arbor
300
When possible, work should be mounted into the vise so it can be done on a __________ .
What is solid vise jaw
300
____ _______ is a machining employed to machine multiple surfaces at the same time
What is Gang milling
300
before you measure the depth of a slot, make sure you clea all _____ from the slot
What is Burrs
400
Avise can be set in an angle with using a ___________ or by using a _______ _________
What is Protractor,and degree possition
400
Always _______ ____ _____ when you're mounting a cutter on a arbor.
What is protect your hands.
400
The _______ _________ _________ is capable doing milling, reaming, and drilling opperation
What is verdical milling machine
400
Face milling cutter should that are over 6" in diameter are usually an ______ _____
What is inserted-tooth
400
A milling cutter must always be keyed into the arbor to pervent it from __________
What is slipping
M
e
n
u