General Safety
What should be obtained from the instructor before working on the miter saw?
Permission
Be sure you can securely _______ or _______ material before making any cut.
Hold or Clamp
Once your cut is complete, you should wait until the saw has stopped __________, before lifting the saw and removing your workpiece.
Spinning
While operating the miter saw, it is never a safe practice to _______ the saw through your workpiece.
Force
Which item listed below is ok to wear in while working in the lab?
Loose Clothing, Gloves, Closed Toed Shoes, Jewelry
Closed Toed Shoes
Before making major adjustments, be sure the _________ is off to the saw?
Power
At any point while operating the miter saw your arms should not ___________.
Cross
Keep your hands at least _____ inches away from the blade when making a cut.
6 (Six)
Always wear proper ___________ protection, even if you already wear eyeglasses.
Eye (Safety Glasses)
Before making a cut on your final piece, make a _________ cut on scrap material.
Practice
Always align the saw blade on the _________ side of the cut line.
Waste
The saw should reach _______ operating speed before making a cut.
Full
The operator should talk to ___________ while operating the miter saw?
No One
When making multiple cuts of the same length, a ____ _____ can be clamped to the saw table to assure accuracy of the cut.
Stop Block
If the miter saw should kickback, continue to hold it firmly in the ________ position, release the off/on switch and wait for the blade to stop rotating.
Down or Downward
The safe operating position for your hands is to hold the _______ with the left hand the _______ with the right hand.
Workpiece and Machine
To prevent making contact or getting tangled in the blade or moving parts, _____________ should be put up or tied back?
Hair
Before beginning any cutting operation make sure all settings are _________ into position.
Locked or Secured
Daily Double!!!
Keep the _______ and _______ clean and free from clutter or scraps when using the miter saw.
Floor and Table
When cutting, place your workpiece with the straight edge tight against the _________ and flat on the __________.
Fence and Table