Power Up
Burr
Give Me Some Room
Work With Me
Roll on
100
This circlip does not follow the "rule" of the sharp edge facing the thrust.
What is the transmission shaft side door bearing circlips.
100
You should always consult this manual for specific storage instructions for a particular model.
What is the owner's manual?
100
The style of valve adjustment that incorporates a threaded adjuster and a locking nut located at the end of the rocker arm by the valve stem.
What is tappet?
100
The name of the service that balances the carburators on a motorcycle.
What is synchronizing?
100
This is the number of spokes in a modern off road motorcycle.
What is 36 spokes?
200
The cassette transmission side door of this model is found under the primary cover.
What is a pre 2004 Sportster?
200
It's ok to store fuel tanks of the material empty.
What is plastic?
200
The name of the disk that is located under the bucket. It comes in various thicknesses to adjust the clearance of valves.
What is a shim?
200
A fan is blown at the motorcycle during the synching procedure for this purpose.
What is to keep the bike from overheating?
200
The up/down run out of a wheel.
What is radial runout?
300
This HD transmission has a neutral switch with 2 wires connected to it.
What is the 1340 transmission?
300
This is what it is called when you remove the airbox lid and spray an oil into the carburators in order to coat the inner engine with preserving oil.
What is fogging?
300
The position the engine must be in when inpecting valve clearance.
What is Top Dead Center of the compression stroke?
300
It is important to check the carburator synch in these two RPM positions on the VL1400 Intruder.
What is 1000rpm and 2000rpm?
300
The process of installing spokes on a wheel build is called this.
What is lacing?
400
This nut is reusable on the 1340 transmission. It should be cleaned and coated with red loctite.
What is the pulley nut?
400
This product is added to fuel to keep it volitile for a longer period of time.
What is fuel stabilizer?
400
The clearance procedure that uses 2 feeler gauges. The smallest service spec and one size larger than the biggest clearance spec.
What is a go/no go valve inspection?
400
This temperature is reached after about 10 minutes of running the engine.
What is opperating temperature?
500
The clue to look for to determine if the engine cases of this Sportster must be split to repair the transmission.
What is a rubber mounted engine.
500
Fuel tanks made of this material should always be stored full.
What is steel?
500
The formula used to figure the size of the new shim to adjust a valve in the shim under bucket system.
What is NEW SHIM=(CURRENT SHIM + CALCULATED CLEARANCE)-THE DESIRED CLEARANCE.
500
This is the carburator that all other are set to.
What is the base carburator?
500
The three major components of a spoke wheel.
What is hub, spokes, and rim?
M
e
n
u