Safety and Hazard Recognition
What is an unplanned incident where equipment gets damaged, but no personal injury occurs?
Property damage
What does a barricade that is red in color mean?
Danger
When working near machinery and equipment such as cranes, where should you never stand regarding the load?
Below it
How many amps of electrical current can kill a person?
Less than 1
When is eye protection required on a job site? Pick the best response.
At all times
Which of the “fatal four” is the cause of the most deaths?
Falls
Ideally, how should you protect workers from a hole in the floor?
Cover it
When there is the threat of flying objects, what PPE should you wear?
Hard hat, eye, and face protection
What should you always do before using a GFCI device or protected circuit?
Test it
What type of glove should an electrician wear?
Rubber-insulated
To whom do you report hazards on the job site?
Supervisor
What is the key to preventing serious injury or death should a fall occur?
Personal fall arrest system (PFAS)
When operating a vehicle and approaching an equipment operator, where should your vehicle never be?
Blind Spot
All tools used in construction should be protected in what way?
With a ground-fault
What type of footwear should never be worn on a job site?
Canvas shoes
What must each product used on a construction site have?
Safety Data Sheet (SDS)
How far away should the foot of the ladder be from the base of the structure to the point where the ladder touches the structure?
1/4
When a vehicle is operated indoors, what in the exhaust can kill or sicken anyone in the vicinity unless there is good ventilation?
Carbon monoxide
What should lightbulbs have to prevent against accidental contact?
Protective guard
What is the name of the lung disease that you can get from inhaling silica dust?
Silicosis
Procrastination, carelessness, and horseplay are examples of what causes of workplace incidents and accidents.
At-risk work habits
How many points of contact should you maintain on a ladder?
3
How much soil can put enough pressure on your lungs to prevent you from breathing?
2-3 Feet
What is lock out/ tag out used for?
To prevent a machine from being turned on well it is being worked on and to prevent a damaged tool from being used.
Positive and negative fit checks should be performed on a respirator _____.
every time it is worn