Chromophare
Two spring arm types
A.C (Classic)
N.F.C
Number of faces on an S-Series service head
Four
Number of inputs and outputs on the HUB
4/5 inputs
4 outputs
Height set for spring arms
2" below the lowest hanging item in the ceiling
System used to find your work order
Salesforce Lightning
Universal Display Mount
Length from level nut to bottom of all thread
2 inches
This cannot be plugged into the vertical USB port on the 3.1 extender
Keyboard
Control ports from 12 to 1 are reserved for these
Non-Stryker products
Document that details all contractor contact information
Chromophare Installation Procedure
MAP12423
S-Series Boom Quality Inspection Procedure
QIP11324
Two devices that must be plugged into a wall outlet
HUB
Audio Amp
Direction of stop location
Toward the patient (unless there is an impeding object)
Must be completed onsite prior to start of installation
Site Readiness Check
CANbus cable used from SK to CFWP
4 pole
Number of stops left in each bearing after install for a TC boom
2 upper
1 middle
1 lower
Three COR Lite installation options
HUB on doc
HUB in cabinet
HUB on boom
First step to de-installing any spring arm assets
Adjust the height
Document that details suspension configuration and boom face plate orientation
PE_SOW
Use for 7 pole commutator pins
Power
Video
Control
Negative flow gases
WAGD
Vacuum
Two devices (pair) needed to send video signal from the endo cam to the hub.
HDMI transmitter
HDMI receiver
Settings used for labeling interstitials
Wiremarker 1.0
9PT Bold
Documents that should be reviewed prior to arriving onsite
PE_SOW
BOM
CADs
PFS