Safemec
Chapter 5 pertains to
Fees (money)
Sched 40 mettallic pipe, Undiluted propane.11 inches water column,.5 pressure drop,is what chart?
6.3.1 (d)
The location of the point of delivery must be acceptable to the?
Serving gas supplier
How far can hangers be spaced for steel 1" pipe
8'
Anodeless riser
The fitting used to attach plastic underground piping to metallic above ground
Initial gas trainee licence fee
$190
Polyethylene plastic pipe
Undiluted propane,11" W.C. ,.5 Pressure drop, is what chart?
6.3.1(k)
Field threaded 1 1/4 pipe must have approximately _____ threads
11
Cathodic protection is used to protect what type of pipe
Underground steel
Shall
A mandatory requirement
How many members on the board would be found in chapter
1
Polyethylene plastic tubing, undiluted propane,11" W.C. ,.5 pressure drop,is what chart?
6.3.1 (M)
What is the minimum schedule pipe you can thread
Schedule 40
The unthreaded portion of gas pipe outlets shall extend not less than _____ inches above the surface of floors
2
BTU
British thermal unit
Continuing education requirements can be found in chapter
4
Using chart 6.3.1 (c) how many btus can a 140 foot run of 3/4 pipe carry
1,290,000
What is the minimum schedule pipe you can press-connect?
Schedule 10
Underground piping systems shall be installed with ______ inches of cover
12
Type 2 clothes dryer
Commercial dryer
Advertising obligations can be found in chapter
6
What is the actual I.D. of 1" polyethylene plastic pipe?
1.077
What is the maximum operating pressure inside a bldg
5 psi
Tracer wire installed with plastic pipe underground shall be a minimum _______ AWG
14
Readily accessible
Having access without removing a panel
Eligibility requirements for fuel gas licensure can be found in chapter
3
Schedule 40 metallic pipe,less than 2 psi,.5 pressure drop,74 feet long,125,000 BTUs,what size pipe?
1"
What is used to bring plastic pipe out of the ground?
Anodeless riser
Name one prohibited location of gas piping
Clothes chute,chimney,gas vent,dumb waiter, elevator shaft, air duct.
Category one vented appliance
Chimney vent, non condensing
Voluntary certification of heating installers is chapter
7
All tables starting with 6.2 are what gas?
Natural
When would you need to install metal tags on meters
When there are multiple meters installed
When gas piping requires slope,it shall be not less than a 1/4 inch per ______ feet
15
Concealed gas pipe
Piping that requires the removal of permanent construction to gain access
What level licence is needed to convert a LP furnace to natural gas
Fuel gas service technician
40 feet of 3/8" OD copper tubing at 2 psi can carry how many BTUS
195,000
A natural gas regulator vent must be _____ feet away from any source of combustion
3 feet
Where and how many valves are required at regulators
1 valve upstream of regulator
Qualified agency
Individual,firm,or company engaged in the installation and testing of gas systems and appliances,and has the training and licensure to do so