Terms and Definitions
PPE
Safety Programs and Energized Work Permit
Safety Related Work Practices
Cite that requirement
100
This person has demonstrated skills and knowledge related to the construction and operation of electrical equipment and installations and has received safety training to identify and avoid the hazards involved.
What is a qualified person
100
Before using a rubber insulating glove. This should be done
What is test for air leaks
100
The 2 conditions in which an energized electrical work permit is required
What is when there is a likelihood of injury due to equipment failure and when work is preformed within the restricted approach boundary
100
The final step in establishing an electrically safe work condition when the possibility of stored energy or induced voltages does not exist.
What is test
100
This code requires that only qualified persons work within the limited approach boundry
What is 130.4(C)(1)
200
When using safety related work practices, this condition should be established before work on conductors and circuit parts begins.
What is electrically safe work condition
200
PPE category 3 requires the use of arc rated clothing rated at this cal/cm2 level
What is 25
200
The results of the shock risk assessment depend on this circuit factor
What is voltage
200
A qualified person working within the limited approach boundary should take care not to cross this boundary without shock protection in place
What is restricted approach boundary
200
An energized work permit is not required to be completed when voltage testing in accordance with this standard
What is 130.2(B)(3)
300
A dangerous condition such that contact or equipment failure can result in electric shock, arc flash burn, thermal burn, or arc blast
What is Electrical Hazard
300
When providing arc flash protection for the back of the head when it is within the arc flash boundary, these two methods would be considered acceptable PPE
What is balaclava and arc rated hood
300
Hazards of electrical work should be communicated to affected employees during this required element of an electrical safety program
What is job briefing
300
After a circuit is de-energized by the automatic operation of a circuit protective device, this should be done before re-energizing the circuit
What is determine that the circuit can be safely energized
300
This section requires contract employers to communicate known hazards to employees working within a host facility
What is 110.3(B)(1)
400
A process that identifies hazards, estimates the potential severity of injury or damage to health, estimates the likelihood of occurrence of injury, and determines if protective measures are required
What is risk assessment
400
The conditions in which boots with electrical hazard identification can be used in place of dielectric foot-ware.
What is never
400
The two options to determine the arc flash risk to select PPE along with determining the arc flash boundary
What is incident energy analysis or arc flash PPE category
400
These 3 alerting techniques are addressed by 70E
What is safety signs, barricades, and attendants
400
In accordance with this section of 70E, test instruments, equipment and their accessories shall be rated for the circuits and equipment where they are utilized
What is 110.4(A)(2)
500
A measurement of the thermal energy impressed on a surface, a certain distance from the source, generate during an electrical arc event which is typically expressed in cal/cm
What is Incident Energy
500
The ANSI standard specification for Rubber Insulating gloves
What is ASTM D120
500
When working with electrical related hazards training specific to first aid, emergency response and resuscitation is required. Annual training shall include CPR and the use of this emergency equipment
What is an AED
500
Before cutting or drilling into equipment, floors, walls or structural elements where a likelihood of contacting energized electrical lines or parts exists, the employer shall perform a risk assessment to create an electrically safe work condition, identify safe work practices and PPE, and this
What is identify and mark the location of conductors, cables, raceways, or equipment
500
Each person who could be exposed directly or indirectly to a source of electrical energy shall be involved in the lockout/tagout process.
What is 120.2(B)(1)
M
e
n
u