PPE
When Must PPE be worn
when a recognized hazard is present
What is the most common File hand tool injury?
Being Stabbed with the tang
SDS Stands For
Safety Data Sheet
The process of displacing air between gage blocks for accurate measurements is called
Wringing
What would the total gauge block stack be for a 6" sine bar set to an angle of 10 Degrees?
1.0149
When working on machinery producing flying chips, the most important personal protection equipment a machinist must wear is
Safety Glasses
The first course of action to take if a material (solid) becomes lodged in the eye is to
Pull the top lid over the bottom lid
Which of the following colors is not found on an HMIS label
The best way to calibrate or check the accuracy of a standard 1-2" micrometer would be to use a
Gauge Block
What would the total gauge block stack be for a 6" sine bar set to an angle of 31 degrees?
3.0902
Government safety regulation state that a person must wear a ________ when working on material stored overhead using cranes or hoists
Hard Hat
The best technique for lifting is to:
Lift with the legs and keep the back straight
The threshold limit value (TLV) is defined as:
The safe limit of unprotected exposure to a material
To check the height of multiple parts with gage blocks, a machinist would use a
Dial Indicator and Digital Height Gauge
What would the total gauge block stack be for a 6" sine bar set to an angle of 22 degrees?
2.2476
_______ Should be used when working with hazardous materials
Gloves
When operating a lathe, long hair, dangling jewelry or loose clothes can
Become caught in the lathe pulling the operator toward the machine
SDS information on new chemicals and materials found in the workplace can be reviewed and discussed at
Right to Know seminars and safety meetings or briefings
Using an 81 block set, What would the required blocks be to gauge a length of .9528?
0.1008,0.102,0.750
What would the total gauge block stack be for a 6" sine bar set to an angle of 50 degrees?
4.5963
If a hazard with immediate danger to the machinist is found. what should the machinist do?
STOP and inform their supervisor
A ________________ is a method to instantly stop a machine from moving, starting, or operating
E-Stop
Where must SDS sheets be stored
Within the working area and accessible to all
Using an 81 block set, What would the required blocks be to gauge a length of 1.6451?
0.1001,0.1050,0.1400,0.4000,1.0000
What would the total gauge block stack be for a 6" sine bar set to an angle of 45 degrees?
4.2426