Onshape Basics
Which button starts a new 2D drawing in a Part Studio?
Sketch
Which rectangle tool starts at one corner and ends at the opposite corner?
Corner rectangle
Which feature adds depth to a flat sketch to make a 3D part?
Extrude
You look straight at the object's front. Which view are you drawing?
Front view
Each grid square is one-quarter inch. How long is a line that crosses 8 squares?
2 inches
After starting a sketch, you select a flat surface to draw on. What is that surface called?
A sketch plane. Also accept: a plane or a flat face.
Pressing D activates which sketch tool?
Dimension
Your flat keychain needs to be 0.25 inches thick. What Extrude depth should you enter?
0.25 in. Also accept: one-quarter inch.
You look straight down at an object from above. Which view are you drawing?
Top view
The front view shows which two dimensions: width, height, or depth?
Width and height
Which button accepts and finishes your sketch: the green check or the red X?
The green check
You need to sketch a round key-ring hole. Which shape tool would you use?
Circle. Also accept: Center point circle.
You right-click a part to change its color. Which command do you choose?
Edit appearance
You look straight at the object's left side. Which view are you drawing?
Front View
The top view shows which two dimensions: width, height, or depth?
Width and depth
Which type of Onshape tab is used to create sketches and model parts?
Part Studio
While editing a sketch, how do you open an existing dimension number so you can change it?
Double-click the dimension number.
To cut material away with Extrude, do you choose New, Add, or Remove?
Remove
What type of drawing shows separate, flat front, top, and side views?
A multiview drawing. Also accept: an orthographic drawing.
A side view shows which two dimensions: width, height, or depth?
Height and depth
Name the three default planes in a new Onshape Part Studio.
Top, Front, and Right
What measurement goes all the way across a circle through its center?
Diameter
Your square sketch is 2 inches by 2 inches. How far should you extrude it to make a cube?
2 inches
This drawing uses vertical lines plus lines slanting 30 degrees left and right to show a box in 3D. Name it.
An isometric drawing
A block's front view is 2 inches wide and 3 inches tall. Its top view is 2 inches wide and 4 inches deep. Give its left-side view dimensions.
4 inches deep by 3 inches tall. Accept either order if the dimensions are correctly identified.