Tools
The proper name for channel lock plyers.
What are V groove players?
Green or bare ground.
What is the grounding conductor?
The height of a service entrance cable over a grass area with no vehicle traffic.
What is ten feet?
I use light pulses to transmit singles. I have the largest bandwidth.
What is fiber optic cable?
Required on all kitchen counter receptacles.
What is GFCI protection?
The trade name for a circular saw.
What is a Skill saw.
Black, Red, or Blue.
What is the ungrounded conductor?
Able to be fastened to a tree.
What is a flood light?
The most common type of wire used to wire residential dwellings.
What is romex or type NM?
3 or more hours.
What is considered a continuous load?
The most common wire strippers used by electricians.
What is T-stripper?
Access without damaging the building.
What is accessible?
This government organazation protects the workers by enforcing safety measures.
What is OSHA?
The most common type of data cable used.
What is Cat5e-7?
NFPA
Who writes the NEC?
The trade name for a jig saw.
What is a saber saw?
Breakers and fuses are labeled as.
What is overcurrent protection?
360 degrees.
What is the total amount of bends in a conduit run without a pull box?
Used in a 100 amp service.
What is 2/0 aluminum SE cable?
The NEC code cycle.
What is three years?
Electricians use this drill to drill holes between stud spaces.
What is a right-angle drill?
The circuit conductors between the final current device and the outlet.
What is a branch circuit?
Protects an electrical system from voltage spikes or lightning strikes.
What is surge protection?
This type of NM cable is used outdoors and can be directly buried.
What is UF?
The NEC is based on this article.
What is article 90?