Potpuri
Other 1
Best guess
Excavation
Safety
100

Spoil piles and/or equipment must be kept at least _____ feet back from the edge of the excavation.

What is 2 feet.

100

A technique that focuses on job tasks as a way to identify and correct hazards is also known as:

What is a "Job ____ _____"

What is a Job Hazard Analysis

100

Equipment such as forklifts, backhoes and scaffolding must maintain at least a ____ foot minimum clearance from overhead power lines.

10 ft

100

 True or false - According to OSHA Table 1 for Crystalline Silica, is a respirator required when using handheld power saw outdoors for more than 4 hours in a day?

TRUE

100

What is the difference between an APR and an SAR?

The APR cleans the air around you and the SAR gives you clean air from a compressed-air cylinder. 

200

OSHA inspections are ____________ conducted without advanced notice.

Almost Always

200

90 percent of incidents are a result of ________?

Human behaviors 

200

A stairway, ladder, ramp or other means of egress must be located in trench excavations that are____ feet or more in depth.

4 ft

200

How far above the landing, does a ladder have to extend?

3 feet

200

What does GFCI stand for?

Ground Fault Circuit Interrupter

300

In construction work, fall protection is needed at how many feet above a lower level?

What is 6 feet

300

In a personal fall arrest system, anchor points must have a minimum breaking strength of:

5,000 lbs

300

How often should vehicles being used at worksites be inspected?

Daily, or at the beginning of each shift

300

When digging around a utility at what distance must you hand dig until the utility is exposed?

18 inches

ZTI= 36 inches

Michigan= 24 inches

300

How is a confined space defined?

What is

Not for human occupancy

One way in or out

Has the potential for hazardous atmosphere

400

Employers are required to post the OSHA Job Safety and Health-It's The Law poster in your workplace.  True or False?

True


400

If you have questions about fall protection or any other safety concerns, who should you ask?

Your Supervisor

400

What is the most significant hazard facing workers in a trench?

Cave-ins

400

OSHA's mission is to:

A. Protect the workers of the general public.

B. Ensure all workers receive minimum wage.

C. Protect the safety and health of American Workers. 

C: Protect the safety and health of America's workers.

400

What is the most common type of work zone collision?

Rear-end-collision

500

The most common cause of fatalities in construction.

What are falls

500

What procedure is used to prevent electrical injuries when there is potential for unexpected energization of equipment that could cause harm to an employee?

What is lockout/ tagout

500

Excavations over 6 feet deep and not obviously visible must be, at minimum:

Barricaded or marked.

500

What type of OSHA inspection is conducted when immediate death or serious harm is likely?

Imminent danger

500

What type of safety gear does a person working on a highway at night need?

High visibility.  Class 2

M
e
n
u