Scaffolding
Fall Protection 1
Hand and Power Tools
Ladders & Stairways
Fall Protection 2
100

Each scaffold shall be capable of supporting how many times the maximum intended load?

What is 4 times the maximum intended load

100
Fall protection is needed when working at or above this height in construction
What is 6 feet or more
100

These types of tools are non-motorized tools used in construction

What is hand tools

100

What are the 2 most common types of ladders used in construction?

What is Stepladders and Extension Ladders

100

At what heigh must iron workers utilize fall protection?

What is 15 feet

200

At what height does OSHA require fall protection on scaffolds?

What is 10 feet or more

200

At what dimension or larger must a hole be protected?

What is 2 inches or greater

200
These types of power tools usually do not have a ground prong at the end of a cord
What is double insulated tools
200

How much must a ladder extend above a higher level when used for access?

What is 3 feet

200
Roofing work may utilize what fall protection system?

What is a warning line system

300

At what scaffold platform height is a safe means of access required?

What is 2 feet or 24 inches

300
Describe the difference between a personal fall restraint system and a personal fall arrest system
What is PFRS will not allow you to fall, only allows employee to get close to an edge, PFAS will allow the employee to fall but will stop them well before they reach the ground.
300
Face shields are always required when using power tools that preform this type of work
What is grinding, chipping, welding tools
300

What is the maximum allowable elevation change without a safe means of access 

What is 19 inches

300

At what distance from the roof unprotected side or edge can non-roofing work utilize a warning line fall protection system?

What is 15 feet

400
What dimension of scaffold platform plank must extend over the support if not secured?

What is a minimum of 6 inches

400

The top rail of a guardrail system should be built between these measurement heights

What is 39" to 42"

400

When working with power tools, one must never remove or modify these safety devices

What are guards

400

What is the most common cause of construction ladder tip overs?

What is Overreaching

400

When there is exposure to falling objects, what must be installed as part of a guardrail system?

What is toeboards or screens

500

At what height ratio shall supported scaffolds be restrained from tipping?

What is ratio of four to one (4:1)

500
What are the 3 main components to a personal fall arrest system?
What is body harness, lifeline, anchor point
500
This type of power tool requires employees to be specially trained in order to be qualified to use it
What is Powder actuated tools
500

What is the maximum possible weight rating of a ladder?

What is 1AA or 375 lbs.

500

With which type of fall hazard is the edge moving or changing during construction?

What is a leading edge

M
e
n
u